1 August 2021 in Journal of Atmospheric and Solar-Terrestrial Physics
3 September 2018 in Radio Science
Spacecraft communication systems operating at X band are strongly affected when the propagation path passes close to the Sun (which can be characterized by the Sun‐Earth‐Probe, SEP, angle). In this paper, a channel model that can generate a time series of signal amplitude and phase, and hence the signal in‐phase and quadrature values, is presented. For X band, the channel model reproduces the observations well for SEP > 0.8°. While the model has not been experimentally validated at SEP angles below 0.8°, the behavior is consistent with measurements reported in the literature and is therefore likely to be suitable for use, with caution, in that region too.
11 February 2011 in Radio Science
Measurements of the Doppler and delay spread associated with HF signals propagating along an oblique (1440 km) path tangential to the midlatitude ionospheric trough are presented for sunspot maximum and minimum. During the day, Doppler spread is independent of solar activity, but for winter and equinoctial nights, it is very much higher at sunspot maximum. The delay spread is also generally higher at sunspot maximum for all seasons and times of day. For sunspot minimum, measurements from a second, longer path (1800 km) are also presented. The observed Doppler and delay spreads are similar for both paths. Finally, a novel method of more accurately deriving the delay spread defined by the International Telecommunication Union (i.e., the largest delay spread including all modes that have a peak power within a user‐defined threshold of that of the strongest mode) from Voice of America coverage analysis program (VOACAP) predictions is presented. For the first time, the predicted values are compared with the measured delay spreads and, while there is generally good agreement at sunspot minimum, the agreement at sunspot maximum tends to be poor because the behavior of the high‐order ionospheric modes (e.g., 3F2) is not well predicted by VOACAP.
1 January 2000 in IEE Proceedings - Microwaves, Antennas and Propagation
Copyright © 2000 IEE. This paper was published as: Microwaves, Antennas and Propagation, IEE Proceedings, 2000, 147 (6), pp. 469-478. This paper is available from http://ieeexplore.ieee.org/. Doi: 10.1049/ip-map:20000817Metadata only entryThe performance of high frequency direction finding systems is known to be related to the frequency of operation and to the propagation mode content of the incoming signal, which is dependent upon the electron density distribution in the ionosphere. In addition to large scale tilts that cause gross deviations of the signal from the great circle direction, irregularities in the ionospheric electron density distribution may be considered as providing a rough reflecting surface for HF radio waves. As a result, signals associated with each propagation mode arrive at the receiver over a range of angles in both azimuth and elevation. Measurements are presented of HF radio signals received over a disturbed, high latitude path. Multiple, closely separated traces were apparent in the time history of the calculated bearings, the precise nature of which depends upon the array geometry and algorithm employed. The presence of these multiple traces is attributed to the behaviour of the DF algorithms when the signals arrive over a range of azimuth and elevation angles due to the rough reflector nature of this disturbed region of the ionosphere
28 May 2019 in Radio Science
The propagation of 5.9‐GHz radio signals and performance of an 802.11p network were measured at three road junctions each having a different density of buildings. The maximum range for which acceptable performance (defined as where the packet delivery ratio was greater than 90%) was dependent on the junction but lies in the range of 45–70 m. While reflections from transient vehicles were often found to have a small positive impact on network performance, this could not be relied upon to provide a reliable improvement in communications. The received signal strength was dependent on the junction type with the strong reflections from buildings located on the opposite side of a T‐junction leading to higher signal strength. Finally, an empirical relationship between the packet delivery ratio and the received signal strength has been established that will allow modelers to link signal strength to network performance for field conditions.