ZnO nanoparticles were successfully deposited on porous silicon (PSi) substrate using spin-coating method. In order to prepare PSi, electrochemical etching was employed to modify the Si surface. Zinc acetate dihydrate was used as a starting material in ZnO sol-gel solution preparation. The postannealing treatments were investigated on morphologies and photoluminescence (PL) properties of the ZnO thin films. Field emission scanning electron microscopy (FESEM) results indicate that the thin films composed by ZnO nanoparticles were distributed uniformly on PSi. The average sizes of ZnO nanoparticle increase with increasing annealing temperature. Atomic force microscopic (AFM) analysis reveals that ZnO thin films annealed at 500°C had the smoothest surface. PL spectra show two peaks that completely correspond to nanostructured ZnO and PSi. These findings indicate that the ZnO nanostructures grown on PSi are promising for application as light emitting devices.
Zinc acetate dehydrate as starting material along with diethanolamine as stabilizer, and isopropyl as a solvent were used to synthesis ZnO thin films in different low molarities. Sol-gel spin coating method was used in depositing ZnO on porous silicon substrate surface. In other to prepare substrate, p-type silicon wafer was etched by dilute hydrofluoric acid to modify the surface becomes porous. Field Emission Scanning Electron Microscopy (FESEM) was employed to study the surface morphology. It is found that ZnO thin films were successfully deposited on the substrates which are composed of ZnO nanoparticles with size ~16 nm to ~22nm. Atomic Force Microscopy (AFM) was used to investigate the surface roughness of thin film. The result shows that the surface roughness is increase as the increases of molarities. Photoluminescence (PL) spectra were done in range of 350 nm to 800 nm. The result shows peaks belonging to ZnO, ZnO defects, and porous silicon respectively are appeared.
Nanostructured ZnO as a seeded was prepared by sol-gel technique on p-type silicon in various low molarities. Zinc acetate, Diethanolamine (DEA), and isopropyl were use as starting material, stabilizer, and solvent respectively. Atomic Force Microscopy (AFM) analysis shows smooth surface and uniform layer were produced in low molarities of precursor. The surface morphology of nanostructured ZnO was analyzed by Field Emission Scanning Electron Microscopic (FESEM). It is found that the nanostructured ZnO were successfully deposited on the silicon substrate with size ~10 nm to ~35 nm. Photoluminescence spectroscopy was employed to study the band gap in room temperature. It shows that very low intensity of PL in 0.05m and 0.1 m. PL intensity become more obvious starting from 0.15 m of precursor concentration.