This paper presents a comprehensive review of the successful application of Severe Plastic Deformation (SPD) in producing ultra-fine grained (UFG) and nano-structured crystalline bulk materials. SPD achieves outstanding grain refinement without significantly altering the original dimensions of the workpiece, making it particularly useful for ductile materials that can withstand large strains under high hydrostatic pressure before failure. The study explores the grain refining mechanism during severe plastic deformation and its impact on the microstructure of metals. It also examines the use of SPD in hard to deform brittle materials like tungsten oxide, B2O3 glasses, and amorphous materials. The paper discusses the advantages and disadvantages of each technique, along with their applications and potential for combining more than one technique. The review is significant because it emphasizes recent progress in process development, which could potentially enable the industrialization of certain SPD techniques for specific applications. This paper fills the gap in the literature by addressing this issue. Overall, the review demonstrates the potential of SPD in metalworking and its application in the development of new UFG materials with improved mechanical properties.
TiN and TiNxOy thin films share many properties such as electrical and optical properties. In this work, a comparison is conducted between TiN (with and without annealing at 400 °C in air and vacuum) and TiNxOy thin films deposited by using RF magnetron sputtering with the same pure titanium target, Argon (Ar) flow rate, nitrogen flow rates, and deposition time on stainless steel substrates. In the case of TiNxOy thin film, oxygen was pumped in addition. The optical properties of the thin films were characterized by spectrophotometer, and Fourier transform infrared spectroscopy (FTIR). The morphology, topography, and structure were studied by scanning electron microscope (SEM), atomic force microscope (AFM), and X-ray diffraction (XRD). The results show that both thin films have metal-like behavior with some similarities in phases, structure, and microstructure and differences in optical absorbance. It is shown that the absorbance of TiN (after vacuum-annealing) and TiNxOy have close absorbance percentages at the visible range of light with an unstable profile, while after air-annealing the optical absorbance of TiN exceeds that of TiNxOy. This work introduces annealed TiN thin films as a candidate solar selective absorber at high-temperature applications alternatively to TiNxOy.
1 October 2016 in International Journal of Pressure Vessels and Piping
This paper presents three-dimensional nonlinear finite element models to understand the uniaxial behavior of concrete-filled fiber reinforced polymer tubes. A stress–strain confined model was introduced for the concrete, a damage criteria based on Hashin's failure model was used to model damage and failure of GFRP tubes, and steel bars were modeled based on classic metal plasticity model. A comparison between experimental results found in the literature and the finite element model was conducted regarding the load-deflection curves and the failure pattern of different test specimens. The model was found to be efficient in capturing the loads and deformations of slender concrete-filled fiber reinforced polymer tube columns. It was then used in a parametric study to understand the effect of different parameters (including fiber orientation, number of layers of (glass-fiber reinforced polymer) and steel reinforcement ratio) on the behavior of concrete-filled fiber reinforced polymer tube under axial compressive loading. It was observed that the behavior of the columns was greatly affected by the investigated analysis parameters.