Friction and wear are two major elements that influence the life of a variety of equipment. According to estimates, as much as 30% of the energy used is dissipated as friction. However, this figure can be reduced by developing materials that enhance surfaces and apply lubricants appropriately. This study aims to analyze the impact of hexagonal boron nitride (h-BN) nanoparticles on the rheological and antiwear characteristics of four distinct oil varieties, namely Society of Automotive Engineers SAE-20W50, soybean, Polyalphaolefin PAO-4, and olive oils. The results of the tribological tests demonstrated a noteworthy enhancement in antiwear characteristics with the addition of 0.2 wt.% of h-BN nanolubricant. Among all nanolubricants, the maximum reduction in coefficient of friction (COF) and wear scar diameter was observed at 0.2 wt.% of h-BN in SAE-20W50 oil. Compared to the base oils, the wear scar diameter decreased by 17.93%, 8.80%, 22.65%, and 24.04% for (soybean oil and 0.2 wt.% of h-BN), (SAE20W50 and 0.2 wt.% of h-BN), (PAO4 and 0.2 wt.% of h-BN), and (olive oil and 0.2 wt.% of h-BN), respectively. Rheological test results indicated that with the addition of h-BN nanoparticles, the viscosity of the base oils significantly increased. The maximum viscosity was observed at 40 °C for SAE20W50 base nanolubricants, according to the rheological measurements.
22 March 2024 in Environment, Development and Sustainability
In this research study, commercial SAE20W40 engine oil and Polyalphaolefin (PAO4) were individually blended with eco-friendly Mahua oil (MO) at volume ratios of 10%, 20%, 30%, and 40% using an ultrasonicator and a magnetic stirrer. The rheological and tribological characteristics of prepared samples were then analyzed by using a rotational Rheometer (MCR-102) and a Four-ball tribo-tester. The chemical characterization of formulated lubricants was analyzed by FT-IR spectroscopy. The worn-out surface of the ball was characterized by using a Scanning Electron Microscope. According to the rheological investigation, the dynamic viscosity of the MO is higher than PAO4 and lower than SAE20W40 engine oil. Blending SAE20W40 into MO increased the dynamic viscosity of MO, whereas blending PAO4 into MO decreased it. At all volume concentrations, the flow behavior of the blended oil showed Newtonian characteristics. The coefficient of friction (COF) for MO exhibited significantly lower values (52% and 46%) when compared to pure SAE20W40 commercial engine oil and PAO4, respectively. The superior antifriction properties, stable frictional torque, and smooth wear scar surface were achieved at 10% PAO4 and40% SAE20W40 into MO. Based on experimentation, it can be suggested that the blending of SAE20W40 and PAO4 intoMO could be a feasible solution for both energy-saving purposes as well as environmental impact.