Yipeng Wang

Dr. Yipeng Wang


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 December 2023 in Processes
Verified
Journal Article
Open access
PDF file
HTHui Tian
Hui Tian
KLkai liao
kai liao
JLJiakang Liu
Jiakang Liu
YCYuchen Chen
Yuchen Chen
JMJun Ma
Jun Ma
MSMingrui Song
Mingrui Song
With the deep development of tight reservoir in Mahu Sag, the trend of rising water cut during flowback concerns engineers, and its control mechanism is not yet clear. For this purpose, the integrated numerical model of horizontal well pattern from fracturing to production was established, and its applicability has been demonstrated. Then the flowback performance from child wells to parent wells and single well to well pattern was simulated, and the optimization method of reasonable flowback strategy was discussed. The results show that the formation pressure coefficient decreases as well patterns were put into production year by year, so that the seepage driving force of the matrix is weakened. The pressure-sensitive reservoir is also accompanied by the decrease of permeability, resulting in the increase of seepage resistance, which is the key factor causing the prolongation of flowback period. With the synchronous fracturing mode of well patterns, the stimulated reservoir volume (SRV) is greatly increased compared with that of single well, which improves the reservoir recovery. However, when the well spacing is less than 200 m, well interference is easy to occur, resulting in the rapid entry and outflow of fracturing fluid, and the increased water cut during flowback. Additionally, the well patterns in target reservoir should adopt a drawdown management after fracturing, with an aggressive flowback in the early stage and a slow flowback in the middle and late stage. With pressure depletion in different development stages, the pressure drop rate should be further slowed down to ensure stable liquid supply from matrix. This research can provide a theoretical guidance for optimizing the flowback strategy of tight oil wells in Mahu sag.

23 July 2025 in Processes
Verified
Journal Article
Open access
PDF file
HLHonglei Liu
Honglei Liu
JHJiangling Hong
Jiangling Hong
WSWei Shu
Wei Shu
XWXiaolei Wang
Xiaolei Wang
XMXinfang Ma
Xinfang Ma
YWYipeng Wang
Yipeng Wang
In the Kelameili volcanic gas reservoir, primary hydraulic fracturing treatments in some wells take place on a limited scale, resulting in a rapid decline in production post stimulation and necessitating re-fracturing operations. However, prolonged production has led to a significant evolution in the in situ stress field, which complicates the design of re-fracturing parameters. To address this, this study adopts an integrated geology–engineering approach to develop a formation-specific geomechanical model, using rock mechanical test results and well-log inversion to reconstruct the reservoir’s initial stress field. The dynamic stress field simulations and re-fracturing parameter optimization were performed for Block Dixi-14. The results show that stress superposition effects induced by multiple fracturing stages and injection–production cycles have significantly altered the current in situ stress distribution. For Well K6, the optimized re-fracturing parameters comprised a pump rate of 12 m3/min, total fluid volume of 1200 m3, prepad fluid ratio of 50–60%, and proppant volume of 75 m3, and the daily gas production increased by 56% correspondingly, demonstrating the effectiveness of the optimized re-fracturing design. This study not only provides a more realistic simulation framework for fracturing volcanic rock gas reservoirs but also offers a scientific basis for fracture design optimization and enhanced gas recovery. The geology–engineering integrated methodology enables the accurate prediction and assessment of dynamic stress field evolution during fracturing, thereby guiding field operations.

26 January 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
DZDan Zhou
Dan Zhou
XMXinfang Ma
Xinfang Ma
BDBo Dong
Bo Dong
MZMinghai Zhang
Minghai Zhang
XZXiao Zhang
Xiao Zhang
QWQing Wang
Qing Wang
This study aims to enhance the development effectiveness of infill wells in the strongly heterogeneous conglomerate reservoir of the Baikouquan Formation in the Bai 21 well area of the Junggar Basin. By optimizing the synergy between fracturing and waterflooding development, it provides a basis for improving the recovery rate of such reservoirs. Integrating geomechanical modeling, fracturing numerical simulation, and reservoir dynamic analysis, the influence mechanisms of fracturing parameters—including pumping rate, pad fluid ratio, and proppant intensity—on fracture propagation, waterflooding response, and stress field evolution were systematically investigated. The results indicate that an optimal parameter combination of a pumping rate of 3.5–4.0 m3/min, a pad fluid ratio of 40–50%, and a proppant intensity of 3.0–4.0 m3/m can create short, wide fractures with half-lengths of 40–45 m, effectively delaying water breakthrough and reducing inter-well interference. Stress field simulations further reveal non-uniform evolution during injection and production: the stress near injection wells initially increases and then decreases, dropping by 9.3% compared to the initial value, while the stress around production wells continuously decreases, with a reduction of up to 37.3%. These findings provide valuable guidance for the synergistic development of fracturing and waterflooding in infill wells in similar strongly heterogeneous conglomerate reservoirs.

8 November 2026 in Energies
Verified
Journal Article
Open access
PDF file
DZDan Zhou
Dan Zhou
XMXinfang Ma
Xinfang Ma
LWLijuan Wang
Lijuan Wang
MZMinghai Zhang
Minghai Zhang
HMHe Ma
He Ma
QWQing Wang
Qing Wang
This research investigates strategies for improving oil recovery from the highly heterogeneous conglomerate deposits of the Lower Karamay Formation in the Bai 21 Well Block of the Junggar Basin. Particular attention is given to the coordinated application of hydraulic fracturing and waterflooding to enhance the effectiveness of infill well development. An integrated approach combining geomechanical modeling, numerical hydraulic-fracturing simulation, and reservoir performance analysis was employed to systematically investigate the effects of proppant ratio, temporary plugging, and proppant placement intensity on fracture propagation, waterflood response, and stress-field evolution. The results show that a proppant ratio of 0.15 and a proppant placement intensity of 2.5 m3/m, combined with temporary plugging and diversion fracturing, can generate short and wide fractures with half-lengths of 40–45 m, effectively mitigating early water channeling and reducing interwell interference. In situ, stress-field simulations further indicate that the stress field evolves non-uniformly during injection and production. The average formation stress initially decreases and subsequently increases, with a maximum reduction of 13.7% relative to the initial value. As waterflooding progresses, the stress gradually recovers, resulting in a final reduction of 10.7%. These findings provide an important reference for the coordinated design of infill-well hydraulic fracturing and waterflooding development in similarly highly heterogeneous conglomerate reservoirs.

19 March 2026 in Processes
Verified
Journal Article
Open access
PDF file
YYYujie Yan
Yujie Yan
QZQuan Zhong
Quan Zhong
PLPandeng Luo
Pandeng Luo
CLChunyue Li
Chunyue Li
XMXinfang Ma
Xinfang Ma
HMHe Ma
He Ma
The bottom water of the Shizhouji Formation tight sandstone reservoir in the Tazhong Shun 9 well area is developed. General fracturing faces the problem of excessive extension of hydraulic fractures and easy communication with water layers. A true triaxial fracturing physical simulation experiment was conducted on the sandstone and mudstone outcrops of the same layer to explore the expansion laws of hydraulic fractures in the tight sandstone reservoir and consider the influence of mudstone interlayers, horizontal stress difference, fracturing fluid flow rate, and viscosity. The mechanism of multi-cluster fractures/artificial fractures penetrating through the layers was revealed. The research results show that the existence of mudstone interlayers greatly increases the complexity of fractures, from 1.88 to 2.96, an increase of 57%. When there is a mudstone interlayer in the rock, the fracturing process is prone to open weak planes, hindering the expansion of hydraulic fractures. The hydraulic fractures of Sample No. 4 were cut off four times and penetrated through the layers once. The larger the flow rate, the greater the complexity of hydraulic fractures, and the easier the fractures penetrate through the layers. The fractures with a large flow rate (200 mL/min) were cut off three times, and the stress difference was larger, the hydraulic fractures tended to be simple, and the penetration through the layers was zero times at a high-level stress difference (18 MPa); the greater the viscosity, the greater the fracture pressure, and the complexity of fractures first increased and then decreased; the greater the viscosity, the more easily the hydraulic fractures penetrate through the layers, with low viscosity cutting off three times, medium viscosity cutting off four times, and high viscosity cutting off five times. Therefore, considering the limitation requirements of the on-site fracturing on the extension of fracture height, it is recommended that the on-site fracturing construction flow rate be 6 m3/min, and the fracturing fluid viscosity be 10 mPa·s.

17 September 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
YCYang Chen
Yang Chen
XZXiao Zhang
Xiao Zhang
LZLiwei Zhang
Liwei Zhang
XMXinfang Ma
Xinfang Ma
QWQing Wang
Qing Wang
YWYipeng Wang
Yipeng Wang
The Jimsar shale reservoir is characterized by low porosity and low permeability. Multistage fracturing of horizontal wells is an effective development method. However, interference between multiple fractures and the presence of well-developed bedding planes limit the effective extension of fractures. To elucidate the initiation and propagation mechanisms of inter-bed fractures in horizontal multi-stage fracturing within shale reservoirs, this study focuses on the Jimusar Shale outcrop and employs large-scale true triaxial hydraulic fracturing physical simulation experiments to construct an experimental model of horizontal multi-stage fracturing. By analyzing fracture morphology, propagation paths, and bedding plane activation characteristics, the study elucidates the fracture propagation patterns under various conditions. Results indicate the following: (1) Increasing the fluid injection rate enhances the net pressure at the fracture tip, effectively overcoming the resistance of bedding planes and promoting the continued propagation of hydraulic fractures across bedding interfaces. (2) Stage spacing affects the coordinated propagation of hydraulic fractures by modifying the stress shadow effect between adjacent fractures. A smaller stage spacing intensifies stress interference, leading to the suppression of local fracture propagation and an increased likelihood of fracture communication. (3) The horizontal stress difference is the primary controlling factor governing fracture propagation direction and bedding penetration capability. A larger horizontal stress difference promotes stable fracture propagation along the direction of the maximum horizontal principal stress and facilitates penetration through bedding planes, whereas a lower horizontal stress difference favors bedding plane activation and fracture deflection, resulting in the formation of a more complex fracture network. The study has established an understanding of the fracture expansion laws under different parameter conditions, which can provide theoretical basis and technical support for the optimization design of multi-stage fracturing parameters in horizontal shale oil wells and the efficient modification of reservoirs.