Rydberg atom, which exhibits a strong response to weak electric fields, is regarded as a promising atomic receiver to surpass sensitivity of conventional receivers. However, its sensitivity is strongly limited by the noise coming from both classical and quantum levels and how to enhance it significantly remains challenging. Theoretically, we strive to optimize the laser array and emphasize the significance of coherence among microwave signals, laser beams power uniformity in laser array for enhancing signal-to-noise ratio (SNR) and promoting the sensitivity to a new level. To enhance practical application mobility and integration, we propose two optimization schemes: six-port fiber-coupled vapor cell probe array and cascaded diffraction gratings. We maintain steady microwave signal coherence in the laser array by using identical vapor cells and positioning the probe lasers on the incident wave’s equal phase plane. Our findings reveal that the wavefront phase difference for the six-port fiber-coupled vapor cell array is 10 degrees, while the cascaded diffraction gratings show a 16 degree difference, with laser intensity uniformity reaching 90.4%. In our experiment, 4.6 dB SNR enhancement was achieved by utilizing the cascaded diffraction gratings to generate a 2×2 probe laser arrays compared to the performance of a laser beam, and it can be enhanced further just by adding more laser beams. In particular, a 2×2 laser array experimental verification yielded 19nv/cm/√Hz@8.57 GHz. More importantly, the intermediate signals of laser array maintain coherence. Therefore, SNR improvement is allowed even in detecting weak target signals amidst strong noise and clutter. The results could offer an avenue for the design and optimization of ultrahigh-sensitivity Rydberg atomic receivers and promote applications in cosmology, meteorology, communication, and microwave quantum technology.
In recent years, electric field measurement techniques based on Rydberg atoms have shown unique advantages in high sensitivity and wideband applications and miniaturization. The Rydberg atom receiver senses the electromagnetic signal using the quantum coherence effect, which overcomes the inherent defects of traditional electronic receivers in terms of thermal noise, insertion loss of microwave devices, and the use of wavelength-dependent antennas, thus providing the Rydberg atomic receivers the potential to become the next generation of microwave receivers. For some particular application scenarios such as radar and communication, superheterodyne reception is a critical technical approach, and the linear dynamic range is an essential factor in evaluating the performance of the superheterodyne receivers. It is challenging to promote the Rydberg atomic receiver without figuring out the influence of system parameters on the linear dynamic range. This paper starts with the response mechanism of the Rydberg atomic superheterodyne receiver, and a theoretical model is established to simulate the atom-microwave responses. Then the harmonics' generation mechanism is discussed, and the atomic linear dynamic range under different probe light Rabi frequencies is studied further. Furthermore, a method to evaluate the antiblocking performance of the system is proposed. This work is expected to provide theoretical guidance for the design and performance optimization of the Rydberg atomic superheterodyne receiver.
Based on Autler–Townes splitting and AC Stark shifts, we present a Rydberg atom-based receiver for determining the amplitude modulation (AM) frequency among a wideband carrier range utilizing a cesium atomic vapor cell. To verify this approach, we measured the signal-to-noise ratio and the data capacity with a 10 kHz AM frequency in the carrier range from 2 GHz to 18 GHz. Without changing the lasers, the working band can be easily extended to a higher range by optimizing the feed antenna and experimental configurations.
22 January 2025 in IEEE Transactions on Microwave Theory and Techniques
The Rydberg atomic heterodyne technique and resonant structures represent two prominent approaches that can notably enhance the sensing sensitivity of Rydberg atomic receivers in the atomic and microwave domains, respectively. However, current implementations exhibit low levels of integration, particularly in the VHF band. This article introduces local oscillator (LO) port-integrated resonators (LOIRs) to synergize these methods, aiming to improve sensitivity and system integration in Rydberg atom-based receivers. Through an analysis of the electric field distribution in the split-ring resonator (SRR), we developed two types of LOIRs: the standing wave type LOIR (SIR) and the traveling wave type LOIR (TIR). Experimental investigations were conducted at 264 MHz using a vapor cell containing cesium atoms in the resonators. Spectral measurements indicate that the SIR and TIR provide enhancement factors of 45.8 and 45.3 dB, respectively. When employing the SIR and TIR for Rydberg atomic heterodyning, sensitivity significantly improved to 104.34 and 105.54 (nV/cm)/$\sqrt{\text{Hz}}$, respectively. Furthermore, in comparison to the SRR setup in the atomic heterodyne scenario, the LO power consumption decreased to 22.4% and 3.7% with the SIR and TIR, respectively. This research represents a significant advancement toward the practical application of Rydberg atomic receivers.
Metasurfaces can arbitrarily manipulate the amplitude, phase, and polarization of optical fields on subwavelength scales. Due to their arbitrary manipulation and compact size, the metasurface can be well integrated with optical fibers. Herein, we demonstrate a polarization-dependent metasurface using birefringent meta-atoms, which can independently control X- and Y-polarization incident light. Each meta-atom allows for the division of phase into 16 steps ranging from 0 to 2π for both X- and Y-polarization, resulting in 256 nanopillars selected from the meta-atom library to satisfy the required phase. With the different effective refractive indices of the cuboid meta-atoms along the X- and Y-axis, we can achieve collimation of the X-polarization emitted beam from an optical fiber while deflecting orthogonally polarized light. As a result, the proposed metasurface collimates an X-polarized beam with a beam radius of 20 μm at z = 1 mm and 43.9 μm at z = 2 mm. Additionally, the metasurface can effectively deflect the Y-polarized beam to 36.01°, consistent with the results of the theoretical computation. The proposed metasurface exhibits a deflection efficiency of 55.6% for Y-polarized beams with a relative polarization efficiency of 82.2%, while the efficiency for the X-polarization is 71.4%. Our work is considered a promising application for optical communication, sensing, and quantum measurement.