The construction industry is responsible for 50% of mineral resource extraction and 35% of greenhouse gas (GHG) emissions. In this context, concrete stands out as one of the most consumed materials in the world. More than 30 billion tons of this material are produced annually, resulting in the extraction of around 19.4 billion tons of aggregates (mainly sand and gravel) per year. Therefore, it is urgent to develop strategies that aim to minimize the environmental impacts arising from this production chain. Currently, one of the most widely adopted solutions is the production of concrete through the reuse of construction and demolition waste. Thus, the objective of this research is to conduct a systematic literature review (SLR) on the use of recycled aggregates in concrete production, aiming to increase urban resilience by reducing the consumption of natural aggregates. An extensive search was performed in one of the most respected scientific databases (Scopus), and after a careful selection process, the main articles related to the topic were considered eligible through the PRISMA protocol. The selected manuscripts were then subjected to bibliographic and bibliometric analyses, allowing us to reach the state-of-the-art on the subject. The results obtained on the replacement rates of natural aggregate by recycled aggregate indicate that the recommendations vary from 20 to 60%, and these rates may be higher as long as the recycled aggregate is characterized, and may reach up to 100% as long as the matric concrete has a minimum compressive strength of 60 MPa. The specific gravity of most recycled aggregates ranges from 1.91 to 2.70, maintaining an average density of 2.32 g/cm3. Residual mortar adhered to recycled aggregates ranges from 20 to 56%. The water absorption process of recycled aggregate can vary from 2 to 15%. The mechanical strength of mixtures with recycled aggregates is significantly reduced due to the amount of mortar adhered to the aggregates. The use of recycled aggregates results in a compressive strength approximately 2.6 to 43% lower than that of concrete with natural aggregates, depending on the replacement rate. The same behavior was identified in relation to tensile strength. The modulus of elasticity showed a reduction of 25%, and the flexural strength was reduced by up to 15%.
Population growth, especially in urban areas, combined with modern levels of social consumption, contribute for a significant increase of waste production. Among the environmental impacts resulting from the operation of landfills, the generation of leachate is certainly one of the most significant and most difficult to control. The composition of leachate is complex and varied; it contains physicochemical and biological characteristics that are aggressive to the soil, water resources, fauna and flora. The technical and operational difficulties to handle it are challenges for waste managers. There are several methods to treat leachate which are widely debated in the literature, each having advantages and disadvantages. The present paper has the objective of carrying out a bibliographical review of leachate treatment from landfills, addressing the main technologies, as well as discussing their applications, advantages, disadvantages and uncertainties. According to what was studied, the technologies that have been found to have the best practical results and, in general, reach the parameters for treated effluent provided for environmental legislations, are those that use filtering membranes. However, one of the major disadvantages of these processes is the generation of a concentrate, which is normally recirculated in the landfill itself.
This article analyzes the evolution of integrated solid waste management systems in small and medium cities of the state of Rio de Janeiro. For this purpose, we applied the Modified Solid Waste Management Condition Index (ICGRm), calculated by a spreadsheet with 40 environmental indicators. A field study was carried out to evaluate ten cities in the state of Rio de Janeiro, among twenty already investigated in a survey carried out in the years 2007-2008. The cities were classified as adequate or inadequate according to the ICGRm scores (range from zero to ten points). The comparative evaluation revealed that four cities presented positive evolution, but only slight, while six cities presented worse scores. In the specific case of Brazil, it shows that public managers have not yet given proper priority to solid waste management, although six years have passed since the establishment of the National Solid Waste Policy through Law 12,305/2010. Ten of the cities evaluated reached the level of management considered adequate by the applied method, either in the evaluation in 2007-2008 or 2016, and some showed slight improvement.
21 September 2022 in Waste Management & Research: The Journal for a Sustainable Circular Economy
This work sought to analyse the main difficulties in implementing and maintaining the selective waste collection in a Brazilian metropolis with more than one million inhabitants. Therefore, a qualitative method was used through in-depth interviews with 18 professionals working in the area of selective collection. The interviews were recorded and the data submitted to content analysis. The results showed the following difficulties: lack of management by the government, low efficiency and limited coverage; poor separation of waste at source; distortions in the selective collection logistics chain and in the distribution of waste by cooperatives; high informality, precarious work and low pay for waste collectors; the presence of middlemen and corruption in the system; and idle capacity of cooperatives and public organs. It was concluded that to overcome the difficulties in the selective collection and for it to be more effective, there is a need to improve the management of the process by the government with greater transparency and integration between the various actors involved, education of the population, better working conditions and remuneration for waste collectors.
This work intends to analyze the use of the qualitative method in studies related to solid waste management. A systematic literature review of the articles published between 2014 and 2019 was made in the Scielo databases (Scientific Electronic Library Online), in the CAPES Journal Portal and Web Of Science. In addition to searching for reference journals in the area of waste (Waste Management and Waste Management and Research) through the descriptors “Qualitative Research” and “Solid Waste”; “Interview”, “Solid Waste” and “Perception” (Interviews, Solid Waste and Perception) and 598 articles were found, and after applying the selection criteria the universe was reduced to a total of 42 publications. The selected articles were analyzed and categorized according to the most relevant aspects such as work objectives, study sample and main results. Qualitative research has been found to be a viable tool and can be employed on a large scale in waste-related studies. It was also found that many studies that use the term “qualitative research” do not have the necessary methodological rigor to be named. It was found that qualitative research is adequate to answer questions in the field of waste studies such as the relationship between waste and public health problems, difficulties in selective collection and other management / treatment actions, environmental impacts, irregular waste disposal and problems in the management of special waste
Environmental licensing is one of the main instruments of the National Environmental Policy, mainly due to its nature of prevention of the significance of environmental damages. After the enactment of complementary law no. 140/11, municipalities were given the explicit competence to license enterprises and activities whose environmental impact is classified as local, provided they have a qualified technical body and a municipal environmental council. After almost six years of enforcement of the aforementioned complementary law, it is verified that most municipalities have not yet been able to implement an efficient and effective environmental licensing system, configuring themselves as mere emitters of environmental licenses. The main problems encountered in municipal environmental licensing are addressed in this paper, such as inconsistencies in the definition of competence of the licensing body, deficiencies in the normative framework, mainly regarding legislation on land use and occupation (zoning), low technical capacity and Lack of independence of municipal environmental agencies, excessive bureaucracy and high processing time, as well as lack of transparency and social control. The analysis of these obstacles points to the need for improvements and effective changes in municipal environmental systems, making environmental licensing play the role of collective protection.