Gerardo Alves da Fonseca Junior

Mr. Gerardo Alves da Fonseca Junior

Instituto Federal Fluminense, Macaé, Rio de Janeiro, Brazil
orcid
Environmental Engineering (MSc) | Civil Engineer | Health an...

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 August 2025 in Infrastructures
Verified
Journal Article
Open access
PDF file
Gerardo Alves da Fonseca JuniorGerardo Alves da Fonseca Junior
Gerardo Alves da Fonseca Junior
JLJuliana C. T. Leite
Juliana C. T. Leite
GMGabriel de Pinna Mendez
Gabriel de Pinna Mendez
Assed N. HaddadAssed N. Haddad
Assed N. Haddad
JSJosé A. F. Silva
José A. F. Silva
Bruno Barzellay Ferreira da CostaBruno Barzellay Ferreira da Costa
Bruno Barzellay Ferreira da Costa
The construction industry is responsible for 50% of mineral resource extraction and 35% of greenhouse gas (GHG) emissions. In this context, concrete stands out as one of the most consumed materials in the world. More than 30 billion tons of this material are produced annually, resulting in the extraction of around 19.4 billion tons of aggregates (mainly sand and gravel) per year. Therefore, it is urgent to develop strategies that aim to minimize the environmental impacts arising from this production chain. Currently, one of the most widely adopted solutions is the production of concrete through the reuse of construction and demolition waste. Thus, the objective of this research is to conduct a systematic literature review (SLR) on the use of recycled aggregates in concrete production, aiming to increase urban resilience by reducing the consumption of natural aggregates. An extensive search was performed in one of the most respected scientific databases (Scopus), and after a careful selection process, the main articles related to the topic were considered eligible through the PRISMA protocol. The selected manuscripts were then subjected to bibliographic and bibliometric analyses, allowing us to reach the state-of-the-art on the subject. The results obtained on the replacement rates of natural aggregate by recycled aggregate indicate that the recommendations vary from 20 to 60%, and these rates may be higher as long as the recycled aggregate is characterized, and may reach up to 100% as long as the matric concrete has a minimum compressive strength of 60 MPa. The specific gravity of most recycled aggregates ranges from 1.91 to 2.70, maintaining an average density of 2.32 g/cm3. Residual mortar adhered to recycled aggregates ranges from 20 to 56%. The water absorption process of recycled aggregate can vary from 2 to 15%. The mechanical strength of mixtures with recycled aggregates is significantly reduced due to the amount of mortar adhered to the aggregates. The use of recycled aggregates results in a compressive strength approximately 2.6 to 43% lower than that of concrete with natural aggregates, depending on the replacement rate. The same behavior was identified in relation to tensile strength. The modulus of elasticity showed a reduction of 25%, and the flexural strength was reduced by up to 15%.

1 October 2025 in Brazilian Journal of Production Engineering
Verified
Journal Article
Open access
PDF file
Gerardo Alves da Fonseca JuniorGerardo Alves da Fonseca Junior
Gerardo Alves da Fonseca Junior
JLJuliana Corrêa Trindade Leite
Juliana Corrêa Trindade Leite
GMGabriel de Pinna Mendez
Gabriel de Pinna Mendez
Assed N. HaddadAssed N. Haddad
Assed N. Haddad
JSJosé Augusto Ferreira da Silva
José Augusto Ferreira da Silva
Bruno Barzellay Ferreira da CostaBruno Barzellay Ferreira da Costa
Bruno Barzellay Ferreira da Costa
Given the increase in global concrete consumption, environmental impacts have also intensified, requiring the construction sector to develop concrete production in line with the Sustainable Development Goals (SDGs). In this context, the use of Construction and Demolition Waste (CDW) as a replacement for natural aggregates emerges as an alternative. Therefore, the objective of this study was to analyze the compressive and tensile strength of concrete produced with recycled aggregate in comparison to reference concrete, through an experimental program using recycled concrete coarse aggregates with maximum diameters of 9.5 mm and 19 mm. For each granulometry, concrete mixtures were produced with natural aggregate replacement ratios of 0%, 30%, 50%, and 100%. Strength tests revealed that the target compressive strength of 25 MPa was achieved by all mixtures, while tensile strength reached between 8% and 12% of compressive test values. The ANOVA statistical method verified that all studied mixtures presented statistically equal mean strengths at 28 days. These results demonstrate that recycled aggregate concrete can be a promising material for the construction sector, while also contributing to SDG 12: Responsible Consumption and Production.