This study investigated the aerodynamic structures generated by transverse jet injection in supersonic flows around high-speed vehicles. The unsteady evolution of these structures was analyzed using an improved delayed detached Eddy simulation (IDDES) approach based on the Reynolds stress model (RSM). The simulations successfully reproduced experimentally observed shock systems and vortical structures. The time-averaged flow characteristics were compared with the experimental results, and good agreement was observed. The flow characteristics were analyzed, with particular emphasis on the formation of counter-rotating vortex pairs in the downstream region, as well as complex near-field phenomena, such as flow separation and shock wave/boundary layer interactions. Time-resolved spectral analysis at multiple monitoring locations revealed the presence of a global oscillation within the flow dynamics. Within these regions, pressure fluctuations in the recirculation zone lead to periodic oscillations of the upstream bow shock. This dynamic interaction modulates the instability of the windward shear layer and generates large-scale vortex structures. As these shed vortices convect downstream, they interact with the barrel shock, triggering significant oscillatory motion. To further characterize this behavior, dynamic mode decomposition (DMD) was applied to the pressure fluctuations. The analysis confirmed the presence of a coherent global oscillation mode, which was found to simultaneously govern the periodic motions of both the upstream bow shock and the barrel shock.
As an active flow-control technology, the counterflowing jet can reduce drag by reconstructing the flow field structure during the re-entry of a vehicle, thereby mitigating the adverse effects of high overload on personnel. However, variations in the angle of attack (AoA) and nozzle mass flow rate tend to induce transitions in its flow field modes and fluctuations in drag reduction performance. To further investigate the aerodynamic interference characteristics of the counterflowing jet during the re-entry process, this study focused on a 2.6% subscale model of the Apollo return capsule. The Reynolds-averaged Navier–Stokes (RANS) equations turbulence model was employed to numerically analyze the effects of different mass flow rates and freestream AoAs on the flow field modes and the drag behavior. The results indicate that with an increase in AoA, the flow field structure of the long penetration mode (LPM) is likely to be destroyed, and the shock wave shape exhibits significant asymmetric distortion. In contrast, the flow field structure of the short penetration mode (SPM) remains relatively stable; however, the bow shock and Mach disk exhibit two typical offset patterns, whose offset characteristics are jointly regulated by the mass flow rate and AoA. In terms of drag characteristics, the AoA significantly weakens the drag reduction effect of the LPM. In contrast, the SPM can maintain a stable drag reduction efficiency of approximately 50% within a certain AoA range. Nevertheless, as the AoA further increases, the drag reduction effect of the SPM gradually diminishes.
Retropropulsion is a deceleration technique that directs thrust along the flight path and serves as the driving technology for vertical rocket recovery and reusability. The flow structure and scales of the retropropulsion flow field are governed by the complex interaction between the jet and the incoming freestream. To investigate this interaction in detail, high-fidelity numerical simulations of a single-nozzle retropropulsion configuration were employed in this work. The effects of thrust coefficients, freestream Mach numbers, and specific jet heat ratios on the flow field structure were systematically examined. Through quantitative analysis of the flow structure, the influence of these parameters was revealed on key flow features, such as the shape and location of shocks and the penetration depth of the jet. The results show that the thrust coefficient is the dominant parameter governing the flow structure. The axial position and characteristic scale of typical flow structures in the interaction region scale linearly with the square root of the thrust coefficient. Further analysis indicates that under hypersonic conditions, the flow structure is insensitive to the freestream Mach number. In contrast, the specific heat ratio of the jet gas affects the penetration and expansion behavior of the jet. Subsequently, the physical model based on the momentum conservation principle and the empirical relation are used to explain the mechanisms by which these parameters affect the flow field structure, thereby enhancing the understanding of retropropulsion flow fields.