Spray Conform is a near-net-shape technology that combines elements of spray forming and Conform. 7075 aluminum alloy rods were fabricated by spray Conform followed by retrogression and a reaging (RRA) heat treatment. The microstructure evolution and the mechanical properties of the spray Conform and the RRA spray Conform 7075 were researched. The spray Conform 7075 sample presents a microstructure with slight hardening precipitates within the matrix and at the grain boundaries, partially recrystallized regions, refined grains and low segregation of the main elements. The final microstructure at RRA aged conditions is mainly composed of fine nanosized and homogeneous precipitates of AlCu and MgZn2, more recrystallized regions and discontinuous precipitates separating out at grain boundaries. The microstructure, no matter the spray Conform 7075 or the RRA-7075, plays a critical role in achieving good mechanical properties combined with high stress-corrosion cracking resistance of the final products.
28 June 2016 in Acta Metallurgica Sinica (English Letters)
The commercial Al-5.72Zn-2.36Mg-1.66Cu (7075) alloys were prepared by the spray Conform (SC) technique consisting of the spray forming and Conform extrusion. The extrusion ratio (ER) was selected as the variable parameter to study the influence mechanism on the microstructures and properties while keeping the other parameters unchanged. The microstructures and properties were investigated by scanning electron microscopy (SEM), scanning transmission electron microscopy (STEM), x-ray diffraction (XRD), electron backscatter diffraction (EBSD) and tensile tests. Concretely, the changing rules of the grains, second phases, tensile strength and elongation with ER were researched respectively. Results indicate that a fine equiaxed grain microstructure with low level of segregation and porosity was achieved by SC. And the intergranular and intragranular phases were fine and homogeneous before and after retrogression and re-aging (RRA). The dispersion and tensile strength are positive to ER, but the grain size (GS) is inverse. Meanwhile, the elongation increases firstly and then decreases with increasing ER.
Gas-assisted continuous casting and extrusion (GAC) process is a novel technique for the continuous preparation of non-equilibrium solidified materials. To evaluate the solidification rate of the melt during GAC, the cooling rate of pure aluminum melt solidified in the wheel groove is calculated, based on the Newtonian heat transfer model and the one-dimensional Fourier heat transfer model. Results show that the cooling rate of the melt during GAC mainly depends on the conduction heat transfer in the wheel groove and the melt thickness. When the thickness of the pure aluminum melt is between 1 and 2.5 mm, the cooling rate can reach 103–104 K s−1, which is much higher than that in CAXTEX (~10 K s−1). It means that GAC is a very effective process in the preparation of non-equilibrium solidification alloys.