Guanghui Ding

Guanghui Ding

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2021 in Physics of Fluids
Verified
Journal Article
Open access
PDF file
GDGuanghui Ding
Guanghui Ding
KCKwing-So Choi
Kwing-So Choi
BMBinghe Ma
Binghe Ma
TKTomonori Kato
Tomonori Kato
WYWeizheng Yuan
Weizheng Yuan
Although blood flows are mostly laminar, transition to turbulence and flow separations are observed at curved vessels, bifurcations, or constrictions. It is known that wall-shear stress plays an important role in the development of atherosclerosis as well as in arteriovenous grafts. In order to help understand the behavior of flow separation and transition to turbulence in post-stenotic blood flows, an experimental study of transitional pulsatile flow with stenosis was carried out using time-resolved particle image velocimetry and a microelectromechanical systems wall-shear stress sensor at the mean Reynolds number of 1750 with the Womersley number of 6.15. At the start of the pulsatile cycle, a strong shear layer develops from the tip of the stenosis, increasing the flow separation region. The flow at the throat of the stenosis is always laminar due to acceleration, which quickly becomes turbulent through a shear-layer instability under a strong adverse pressure gradient. At the same time, a recirculation region appears over the wall opposite to the stenosis, moving downstream in sync with the movement of the reattachment point. These flow behaviors observed in a two-dimensional channel flow are very similar to the results obtained previously in a pipe flow. We also found that the behavior in a pulsating channel flow during the acceleration phase of both 25% and 50% stenosis cases is similar to that of the steady flow, including the location and size of post-stenotic flow separation regions. This is because the peak Reynolds number of the pulsatile flow is similar to that of the steady flow that is investigated. The transition to turbulence is more dominant for the 50% stenosis as compared to the 25% stenosis, as the wavelet spectra show a greater broadening of turbulence energy. With an increase in stenosis to 75%, the accelerating flow is directed toward the opposite wall, creating a wall jet. The shear layer from the stenosis bifurcates as a result of this, one moving with the flow separation region toward the upper wall and the other with the wall jet toward the bottom wall. Low wall-shear stress fluctuations are found at two post-stenotic locations in the channel flow – one immediately downstream of the stenosis over the top wall (stenosis side) inside the flow separation region, and the other in the recirculation region on the bottom wall (opposite side of the stenosis).

15 August 2018 in Sensors
Verified
Journal Article
Open access
PDF file
GDGuanghui Ding
Guanghui Ding
BMBinghe Ma
Binghe Ma
JDJinjun Deng
Jinjun Deng
WYWei-Zheng Yuan
Wei-Zheng Yuan
KLKang Liu
Kang Liu
A micro-floating element wall shear stress sensor with backside connections has been developed for accurate measurements of wall shear stress under the turbulent boundary layer. The micro-sensor was designed and fabricated on a 10.16 cm SOI (Silicon on Insulator) wafer by MEMS (Micro-Electro-Mechanical System) processing technology. Then, it was calibrated by a wind tunnel setup over a range of 0 Pa to 65 Pa. The measurements of wall shear stress on a smooth plate were carried out in a 0.6 m × 0.6 m transonic wind tunnel. Flow speed ranges from 0.4 Ma to 0.8 Ma, with a corresponding Reynold number of 1.05 × 106~1.55 × 106 at the micro-sensor location. Wall shear stress measured by the micro-sensor has a range of about 34 Pa to 93 Pa, which is consistent with theoretical values. For comparisons, a Preston tube was also used to measure wall shear stress at the same time. The results show that wall shear stress obtained by three methods (the micro-sensor, a Preston tube, and theoretical results) are well agreed with each other.