The research is aimed at investigating ammonia in a compression ignition internal combustion engine as a promising alternative fuel towards decarbonization. This study presents energy and exergy assessments of a low-power engine for three cases of fuel supply, diesel oil, biodiesel oil, and ammonia with pilot biodiesel oil, across the entire engine’s range. While diesel or biodiesel was administered directly into the engine cylinder, the ammonia was delivered through port injection. The results show that the maximum thermal efficiency of 33.56% and exergy efficiency of 31.88% were found at 1800 rpm and 71% load for the diesel fuel system. For the biodiesel fuel system, the efficiencies were 32.72% and 30.93%, respectively, at 1800 rpm and 100% load, and for the ammonia with pilot biodiesel system, they were at 31.98% and 30.04%, respectively, for the same rpm and load. The exergy assessment indicates that exergy destruction, which accounts for the irreversibility of processes such as combustion and friction, is responsible for the greatest loss of useful energy. Optimizing these processes could significantly improve the engine’s performance for all three fuel cases. This research found that ammonia could successfully substitute diesel or biodiesel fuel, as the engine’s efficiency was comparable in all three tested scenarios; however, further research and optimization in terms of the ammonia-fueled engine emissions are required.
This research considers a preliminary comparative technical evaluation of two micro-gas turbine (MGT) systems in combined heat and power (CHP) mode (100 kWe), aimed at supplying heat to a residential community of 15 average-sized buildings located in Central Europe over a year. Two systems were modelled in Ebsilon 15 software: a natural gas case (benchmark) and an ammonia-fueled case, both based on the same on-design parameters. Off-design simulations evaluated performance over variable ambient temperatures and loads. Idealized, unrecuperated cycles were adopted to isolate the thermodynamic impact of the fuel switch under complete combustion assumption. Under these assumptions, the study shows that the ammonia system produces more electrical energy and less excess heat, yielding marginally higher electrical efficiency and EUF (26.05% and 77.63%) than the natural gas system (24.59% and 77.55%), highlighting ammonia’s utilization potential in such a context. Future research should target validating ammonia combustion and emission profiles across the turbine load range, and updating the thermodynamic model with a recuperator and SCR accounting for realistic pressure losses.