An approach for the formation of intermetallic coatings on the titanium surface based on titanium aluminides is proposed. The approach involves producing a layered steel-aluminum-titanium metal composite via explosive welding, followed by heat treatment to form a diffusion zone at the steel–aluminum interface with a thickness of more than 30 μm, sufficient for the spontaneous separation of the steel layer. As a result, an aluminum layer approximately 0.3 mm thick remains on the titanium surface. Subsequent heating at temperatures of 700–850 °C, below the allotropic transformation temperature of titanium, results in the transformation of the aluminum layer into titanium aluminides. The formation of the intermetallic coating structure occurs as a result of the upward transportation of TiAl3 fragments separated from the reaction zone by circulating melt flows. With increasing heat treatment time, these fragments become separated by the Al2O3 oxide phase.
The results of finite element modeling of the rolling of a three-layer asymmetric steel St3 + aluminum AD1 + titanium VT1-0 composite and a five-layer symmetric St3 + AD1 + VT1-0 + AD1 + St3 composite are presented. Differences in the stress-strain state of the composites depending on the symmetry of the arrangement are demonstrated. It is established that the symmetric arrangement ensures the straightness of the composite after rolling, while the asymmetric arrangement leads to its bending.