Precipitation is one of the essential variables in rainfall-runoff modeling. For hydrological purposes, the most commonly used data sources of precipitation are rain gauges and weather radars. Recently, multi-satellite precipitation estimates have gained importance thanks to the emergence of Integrated Multisatellite Retrievals for Global Precipitation Measurement (IMERG GPM), a successor of a very successful Tropical Rainfall Measuring Mission (TRMM) mission which has been providing high-quality precipitation estimates for almost two decades. Hydrological modeling of mountainous catchment requires reliable precipitation inputs in both time and space as the hydrological response of such a catchment is very quick. This paper presents an inter-comparison of event-based rainfall-runoff simulations using precipitation data originating from three different sources. For semi-distributed modeling of discharge in the mountainous river, the Hydrologic Engineering Center-Hydrologic Modelling System (HEC-HMS) is applied. The model was calibrated and validated for the period 2014–2016 using measurement data from the Upper Skawa catchment a small mountainous catchment in southern Poland. The performance of the model was assessed using the Nash–Sutcliffe efficiency coefficient (NSE), Pearson’s correlation coefficient (r), Percent bias (PBias) and Relative peak flow difference (rPFD). The results show that for the event-based modeling adjusted radar rainfall estimates and IMERG GPM satellite precipitation estimates are the most reliable precipitation data sources. For each source of the precipitation data the model was calibrated separately as the spatial and temporal distributions of rainfall significantly impact the estimated values of model parameters. It has been found that the applied Soil Conservation Service (SCS) Curve Number loss method performs best for flood events having a unimodal time distribution. The analysis of the simulation time-steps indicates that time aggregation of precipitation data from 1 to 2 h (not exceeding the response time of the catchment) provide a significant improvement of flow simulation results for all the models while further aggregation, up to 4 h, seems to be valuable only for model based on rain gauge precipitation data.
Precipitation is a key variable in the hydrological cycle and essential input data in rainfall-runoff modeling. Rain gauge data are considered as one of the best data sources of precipitation but before further use, the data must be spatially interpolated. The process of interpolation is particularly challenging over mountainous areas due to complex orography and a usually sparse network of rain gauges. This paper investigates two deterministic interpolation methods (inverse distance weighting (IDW), and first-degree polynomial) and their impact on the outputs of semi-distributed rainfall-runoff modeling in a mountainous catchment. The performed analysis considers the aspect of interpolation grid size, which is often neglected in other than fully-distributed modeling. The impact of the inverse distance power (IDP) value in the IDW interpolation was also analyzed. It has been found that the best simulation results were obtained using a grid size smaller or equal to 750 m and the first-degree polynomial as an interpolation method. The results indicate that the IDP value in the IDW method has more impact on the simulation results than the grid size. Evaluation of the results was done using the Kling-Gupta efficiency (KGE), which is considered to be an alternative to the Nash-Sutcliffe efficiency (NSE). It was found that KGE generally tends to provide higher and less varied values than NSE which makes it less useful for the evaluation of the results.
As the world is changing, mainly due to climate change, extreme events such as floods and droughts are becoming more frequent and severe. Considering this, the predictive modeling of flow in small mountain catchments that are particularly vulnerable to flooding is critical. Rainfall data sources such as rain gauges, meteorological radars, and satellites provide data to the hydrological model with a lag. Only numerical weather predictions can achieve this in advance, but their estimates are often subject to considerable uncertainty. This article aims to verify whether Global Environmental Multiscale numerical precipitation prediction can be successfully applied for event-based rainfall–runoff hydrological modeling. These data were verified for use in two aspects: the flow modeling and determination of antecedent moisture conditions. The results indicate that GEM data can be satisfactorily used for hydrological modeling, and particularly good simulation results are obtained when significant rainfall occurs. In addition, these data can be used to correctly estimate the AMC groups for each sub-catchment in advance, which is one of the key elements flowing into the amount of projected outflow in the catchment. It is worth noting that, according to the literature review conducted by the article’s author, this is the first published attempt to use GEM data directly in applied hydrological applications.
Civil engineering structures are highly responsible for the negative aspects of urbanization on the hydrological cycle. Due to the land cover change and an increase of impervious areas the risk of flooding can rise significantly. The paper presents the impact of urbanization processes on surface runoff estimation for a small mountainous catchment between 1990-2012.