Thermochemical adsorption energy storage is a potential energy utilization technology. Among these technologies, the composite energy storage material prepared by K2CO3 and expanded vermiculite (EVM) shows excellent performance. In this paper, the influence of the preparation process using the impregnation method and vacuum impregnation method on K2CO3/EVM composite material is studied. The preparation plan is further optimized with the solution concentration and the expanded vermiculite particle size as variables. In the experiment, mercury intrusion porosimetry (MIP) is used to measure the porosity and other parameters. Additionally, with the help of scanning electron microscopy (SEM), the morphological characteristics of the materials are obtained from a microscopic point of view. The effects of different preparation parameters are evaluated by comparing the experimental results. The results show that the K2CO3 specific gravity of the composite material increases with the increase of the vacuum degree, up to 70.440 wt.% (the vacuum degree is 6.7 kPa). Expanded vermiculite with a large particle size (3~6 mm) can carry more K2CO3, and content per cubic centimeter of K2CO3 can be as high as 0.466 g.
The dry scroll vacuum pump is a kind of variable capacity dry vacuum pump that is applied in chemical, pharmaceutical, semiconductor, and scientific instruments. Analyzing the thermodynamic characteristics of the scroll vacuum pump and studying the impact of operating temperature on its consistent performance are necessary for the design and application of the cooling system of the scroll vacuum pump. Based on the dynamics mesh method, the computational fluid dynamics (CFD) simulation model of a multi-stage dry scroll vacuum pump is established in this study. Under the suction pressure of 1000 Pa, the simulation calculation is carried out at different operating temperatures of fixed scrolls (25 °C, 45 °C, and 65 °C). The results show that the pumping speed, the gas compression power, and the energy efficiency ratio are significantly affected by different temperatures. The operating temperature of the pump has been reduced from 65 °C to 25 °C, the pumping speed is increased by approximately 5.97%, the gas compression power is increased by approximately 4.32%, and the energy efficiency ratio is increased by approximately 1.745%. This research provides a transient simulation method using dynamic mesh technology for the study of the dry scroll vacuum pump, and the results can provide a theoretical basis for the design and application of the cooling system of the dry scroll vacuum pump.