This study addresses a critical aspect of hard turning—surface roughness at shallow depths of cut comparable to the cutting edge radius—by analyzing the influence of cutting parameters on surface integrity. Its findings are essential for optimizing finishing operations, as they highlight the importance of considering the cutting edge radius when determining minimum machining allowances. To estimate the minimum undeformed chip thickness, experiments were carried out on EN 100Cr6 hardened steel (60 HRC) using both free and constrained cutting methods, across two cutting speeds and three depths of cut. Advanced analysis of high-resolution 3D surface data with nonlinear dynamic techniques enabled the calculation of correlation entropy, correlation dimension, and noise levels, offering deeper insight into the mechanisms affecting surface quality. The findings confirmed that surface profiles exhibit a deterministic nature, as evidenced by multifractal spectrum analysis. Reducing the cutting depth led to increased peak density and surface complexity, while higher cutting speeds resulted in more ordered surfaces. Additionally, the relative length function revealed scale-dependent changes in surface complexity. Fractal dimension and correlation entropy emerged as effective diagnostic tools, offering insights into process stability and surface characteristics, thus providing a quantitative basis for optimizing finishing operations in hard turning.
Manufacturing in modern industrial sectors involves the machining of components where the undeformed chip thickness inevitably decreases to values comparable to the tool edge radius. Under such conditions, the ploughing effect between the workpiece and the tool becomes dominant, followed by the noticeable formation of a stagnation zone. This paper presents research focused on the analysis of the cutting process for small cross-sections of the removed layers, based on cutting force components. This study investigated the machining of two titanium alloy grades—Ti Grade 5 (Ti-6Al-4V) and Ti Grade 2—with the main focus on process stability. A material separation model was analyzed to demonstrate the mechanism of material flow within the cross-section of the machined layer. It was found that the material has a limited ability to flow sideways at the boundary of the chip thickness, thus determining the probable size of the stagnation zone in front of the cutting edge. Orthogonal cutting experiments enabled the determination of the minimum chip thickness coefficient for constant temperature conditions, independent of the tool edge radius, as 0.313. In oblique cutting tests, the sensitivity of thin-layer machining was demonstrated for the determined values of minimum undeformed chip thickness. By applying the 0–1 test for chaos, the measurement time (parameter ) was determined for both titanium alloys to determine the range of observable chaotic behavior. The analyses confirmed that Ti Grade 2 enters chaotic dynamics much more rapidly than Ti Grade 5 and displays local cutting instabilities independent of the uncut chip thickness.