Studies have already established that the mechanical properties of Babbitt coatings significantly depend on the microstructural characteristics, such as the amount and distribution of intermetallic compounds dispersed in a soft solid solution matrix. For Sn–Sb–Cu-based Babbitt coatings, the formation of SbSn- and CuSn-based precipitates has a substantial influence on the resulting microhardness and thus determines the maximum load carrying capacity. Thermal spraying of Sn-based Babbitt coatings results in a relatively more refined structure of these precipitates than in common manufacturing processes, such as casting, due to the thermal processing conditions. This study aims to evaluate the effect of the temperature of the propellant gas and substrate temperature on the microstructural characteristics of Sn–Sb–Cu-based Babbitt coatings deposited by low pressure cold spraying (LPCS). The deposits were examined for their phase composition, microhardness and mesoscopic structure. It was found that the coatings were mainly composed of Sb2Sn23, Sb0.49Sn0.51 and Sorosite (CuSn or CuSb0.115Sn0.835), regardless of the substrate temperature or temperature of the propellant gas to be investigated. For a gas temperature above 300 °C, an increased microhardness was observed, which correlates with the appearance of a more homogenous distribution of Sb0.49Sn0.51 dispersed in a soft Sn-rich solid solution matrix.
31 March 2026 in Journal of Thermal Spray Technology
Cr 3 C 2 -NiCr coatings are widely used to protect industrial components in harsh environments due to their exceptional wear resistance, high-temperature oxidation protection, and corrosion resistance. Such coatings are typically produced using the high-velocity oxygen fuel (HVOF) spraying process. However, internal coating applications pose challenges such as restricted surface access, limited experience with optimized process parameters and the difficulty of producing fine chromium carbides, which results in coarser particles compared to powders like WC-CoCr. This study investigates the application of a commercially available Cr 3 C 2 -NiCr powder using the ID-HVOF coating process. A Central Composite Design (CCD) within a Design of Experiments (DoE) framework was employed to analyze the effects of key process parameters—kerosene, hydrogen, oxygen, and the powder feed rate—on the coating performance. The results confirm that the validation test successfully produced a coating that matches the predicted parameters from the CCD. This study underscores the importance of statistical design in optimizing the ID-HVOF process, enabling improved mechanical properties and reliable coating quality for the internal surface protection using Cr 3 C 2 -NiCr powders.
Friction-spinning is an incremental thermomechanical forming process that has huge potential due to its simple yet effective mechanism of utilising friction between a rotating workpiece and a forming tool to increase the workpiece’s temperature, which reduces the required forces and increases formability during the forming process. Despite the simplicity of the process’s setup, the thermomechanical loads and high relative velocities involved, especially in the contact zone, make the application of classical methods for characterising friction inaccurate. It is therefore essential to find a way to describe the frictional behaviour under real process conditions to be able to gain a holistic understanding of the process and the effect of the adjustable parameters on the outcome, especially the temperature. To achieve this goal, an experimental setup that considers the actual process boundary conditions in forming tubes made of EN AW-6060 was used to measure in situ normal and frictional forces, in addition to process temperatures, under varying rotational speed and feed rate values.