The goal of this paper is to assess the suitability of hybrid PVT systems for the provision of electricity and hot water (space heating is not considered) in the UK domestic sector, with particular focus on a typical terraced house in London. A model is developed to estimate the performance of such a system. The model allows various design parameters of the PVT unit to be varied, so that their influence in the overall system performance can be studied. Two key parameters, specifically the covering factor of the solar collector with PV and the collector flow-rate, are considered. The emissions of the PVT system are compared with those incurred by a household that utilises a conventional energy provision arrangement. The results show that for the case of the UK (low solar irradiance and low ambient temperatures) a complete coverage of the solar collector with PV together with a low collector flow-rate are beneficial in allowing the system to achieve a high coverage of the total annual energy (heat and power) demand, while maximising the CO2 emissions savings. It is found that with a completely covered collector and a flow-rate of 20L/h, 51% of the total electricity demand and 36% of the total hot water demand over a year can be covered by a hybrid PVT system. The electricity demand coverage value is slightly higher than the PV-only system equivalent (49%). In addition, our emissions assessment indicates that a PVT system can save up to 16.0tonnes of CO2 over a lifetime of 20years, which is significantly (36%) higher than the 11.8tonnes of CO2 saved with a PV-only system. All investigated PVT configurations outperformed the PV-only system in terms of emissions. Therefore, it is concluded that hybrid PVT systems offer a notably improved proposition over PV-only systems

A techno-economic analysis is undertaken to assess hybrid PV/solar-thermal (PVT) systems for distributed electricity and hot-water provision in a typical house in London, UK. In earlier work (Herrando et al., 2014), a system model based on a PVT collector with water as the cooling medium (PVT/w) was used to estimate average year-long system performance. The results showed that for low solar irradiance levels and low ambient temperatures, such as those associated with the UK climate, a higher coverage of total household energy demands and higher CO2 emission savings can be achieved by the complete coverage of the solar collector with PV and a relatively low collector cooling flow-rate. Such a PVT/w system demonstrated an annual electricity generation of 2.3MWh, or a 51% coverage of the household’s electrical demand (compared to an equivalent PV-only value of 49%), plus a significant annual water heating potential of to 1.0MWh, or a 36% coverage of the hot-water demand. In addition, this system allowed for a reduction in CO2 emissions amounting to 16.0 tonnes over a life-time of 20years due to the reduction in electrical power drawn from the grid and gas taken from the mains for water heating, and a 14-tonne corresponding displacement of primary fossil-fuel consumption. Both the emissions and fossil-fuel consumption reductions are significantly larger (by 36% and 18%, respectively) than those achieved by an equivalent PV-only system with the same peak rating/installed capacity. The present paper proceeds further, by considering the economic aspects of PVT technology, based on which invaluable policy-related conclusions can be drawn concerning the incentives that would need to be in place to accelerate the widespread uptake of such systems. It is found that, with an electricity-only Feed-In Tariff (FIT) support rate at 43.3p/kWh over 20years, the system cost estimates of optimised PVT/w systems have an 11.2-year discounted payback period (PV-only: 6.8years). The role and impact of heat-based incentives is also studied. The implementation of a domestic Renewable Heat Incentive (RHI) at a rate of 8.5p/kWh in quarterly payments leads to a payback reduction of about 1year. If this incentive is given as a one-off voucher at the beginning of the system’s lifetime, the payback is reduced by about 2years. With a RHI rate of 20 p/kWh (about half of the FIT rate) PVT technology would have approximately the same payback as PV. It is concluded that, if primary energy (currently dominated by fossil fuels) and CO2 emission minimisation are important goals of national energy policy, PVT systems offer a significantly improved proposition over equivalent PV-only systems, but at an elevated cost. This is in need of careful reflection when developing relevant policy and considering technology incentivation. Currently, although heat outweighs electricity consumption by a factor of about 4 (by energy unit) in the UK domestic sector, the support landscape has strongly favoured electrical microgeneration, being inclined in favour of PV technology, which has been experiencing a well-documented exponential growth over recent decades