In this paper, a lightweight permanent magnet in-wheel (LW-PMIW) motor is proposed. This research focuses on using a multi-modulation design to enhance the amplitude of the fundamental wave while suppressing high-order harmonics, thereby enabling the motor to achieve high output torque, a light weight, and a high efficiency. Firstly, a combined trade-off factor related to motor mass, losses, and torque is defined specifically to provide guidance for the design. Secondly, a dual-rotor structure is adopted, and a harmonic injection (HI) design is applied to the permanent magnets (PMs). By designing a targeted harmonic injection ratio coefficient, the non-working harmonics of the PM magnetomotive force (MMF) can be weakened. Then, two iron modulating blocks are introduced to asynchronously modulate the PM MMF, which can further enhance the fundamental amplitude and improve the distribution of the airgap magnetic field. Finally, to verify the effectiveness of the multi-modulation design, the electromagnetic performance of the motor is evaluated and analyzed. The analytical and simulation results show that the torque of the proposed motor can reach 35.4 Nm, which is an increase of 19.6% while the torque ripple remains unchanged compared with the initial motor. Meanwhile, the output power increased by 0.37 kW. Hence, the rationality and effectiveness of the motor design are verified.
In this paper, a high-torque and low-cogging-torque double-sided permanent magnet (DS-PMFM) motor is proposed. The research focuses on adopting structure of stator split-tooth and unequal-width rotor poles, enabling the motor to have high output torque, low torque ripple, and low cogging torque. It is found that the DS-PMFM motor causes a non-negligible deterioration of cogging torque and torque ripple while increasing the output torque compared with the single-sided permanent magnet (SS-PMFM) motor. Based on this, in order to achieve the comprehensive performance improvement of a high torque density, low cogging torque, and low torque ripple for the motor, research is carried out from three perspectives: pole-slot ratio, stator modulation pole split-tooth shape design, and unequal-width rotor poles design. Ultimately, the final topology is obtained through optimization. Through comparative analysis, it was shown that the torque performance of the proposed DS-PMFM motor has been effectively improved, providing effective guidance for the design of this type of motor.