The efficiency of kesterite-based solar cells is limited by various non-ideal recombination paths, amongst others by a high density of defect states and by the presence of binary or ternary secondary phases within the absorber layer. Pronounced compositional variations and secondary phase segregation are indeed typical features of non-stoichiometric kesterite materials. Certainly kesterite-based thin film solar cells with an off-stoichiometric absorber layer composition, especially Cu-poor/Zn-rich, achieved the highest efficiencies, but deviations from the stoichiometric composition lead to the formation of intrinsic point defects (vacancies, anti-sites, and interstitials) in the kesterite-type material. In addition, a non-stoichiometric composition is usually associated with the formation of an undesirable side phase (secondary phases). Thus the correlation between off-stoichiometry and intrinsic point defects as well as the identification and quantification of secondary phases and compositional fluctuations in non-stoichiometric kesterite materials is of great importance for the understanding and rational design of solar cell devices. This paper summarizes the latest achievements in the investigation of identification and quantification of intrinsic point defects, compositional fluctuations, and secondary phases in non-stoichiometric kesterite-type materials.
An off-stoichiometric but single phase Cu1.95Zn1.1Sn0.96Se4 kesterite powder was investigated by temperature dependent transient surface photovoltage (SPV) spectroscopy. SPV signals excited at different wavelengths were transformed into SPV spectra that depended on the response time of measurement. Shallow electronic states and states with transition energies at 0.83 eV or 0.78… 0.9 eV were distinguished. The temperature dependence of the band gap of Cu1.95Zn1.1Sn0.96Se4 was obtained. Results were discussed on the basis of defects in Cu-poor and Zn-rich kesterite.
The performance of solar cells is presently limited by low values of open-circuit voltage which are a consequence of strong band tailing and high level of nonradiative recombination. Recently, the partial substitution of Cu, Zn, and Sn by other elements has shown the potential to overcome this limitation. We explored the structural changes and the effect on the optoelectronic properties of the partial substitution of Cu with Ag in . This paper clarifies the crystal structure of solid solution series, deducing possible cationic point defects and paying special attention to the presence of Cu/Zn disorder with a combination of neutron and x-ray diffraction. The optoelectronic properties of the solid solution series are assessed using reflection and quantitative photoluminescence spectroscopy, which allows us to estimate the fraction of nonradiative recombination, which would contribute to the open-circuit voltage loss in devices. The results strongly suggest Ag incorporation as a promising route to eliminate Cu/Zn disorder and to reduce nonradiative recombination losses in .
Chalcogenide perovskites have emerged as a promising class of materials for the next generation of optoelectronic applications, with BaZrS 3 attracting significant attention due to its wide bandgap, earth‐abundant composition, and thermal and chemical stability. However, previous studies have consistently reported weak and ambiguous photoluminescence (PL), regardless of synthesis method, raising questions about the intrinsic optoelectronic quality of this compound. In this work, strong, band‐to‐band‐dominated PL is demonstrated at room temperature in high‐quality BaZrS 3 single crystals, with a PL quantum yield of ∼0.005%. Despite the narrow, single‐component PL emission band, time‐resolved PL measurements reveal a carrier lifetime of 1.0 ± 0.2 ns. To understand the origin of the strong PL and short carrier lifetime, multiwavelength excitation and polarization‐dependent Raman measurements are performed, supported by first‐principles lattice dynamics calculations. All 23 theoretically predicted Raman‐active modes and their symmetries are identified, providing a comprehensive reference for future studies. These results indicate that phonon‐assisted carrier decay and nontrivial electron‐phonon interactions contribute to the short carrier lifetimes, as evidenced by Raman spectroscopy and DFT calculations. Further studies on compositional variations or partial cation/anion substitutions can mitigate electron‐phonon coupling and enhance carrier lifetimes. By establishing a detailed reference for the intrinsic vibrational and optoelectronic properties of BaZrS 3 , this work paves the way for further advancements in chalcogenide perovskites for energy and optoelectronic technologies.