Ji Li

Dr. Ji Li


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 July 2025 in Coatings
Verified
Journal Article
Open access
PDF file
JLJi Li
Ji Li
JLJun Luo
Jun Luo
YLYang Liu
Yang Liu
Silver nanowire (AgNW)-based transparent conductive films are essential for flexible electronics due to their superior optoelectronic properties and mechanical flexibility. This review examines the characteristics and fabrication methods of AgNW thin films in detail. Among various fabrication techniques, the AgNW thin film produced by silk-screen printing exhibits the highest quality factor of 568.47, achieving 95.3% visible light transmittance of 95.3% and 13.6 Ω/sq sheet resistance. Ensuring the stability of AgNW films requires the deposition of protective layers through physical or chemical approaches. This review also systematically evaluates the different methods for preparing these protective layers, including their respective advantages and limitations. Furthermore, the review proposes strategies to enhance the conductivity, transparency, and flexibility of AgNW films. Finally, it discusses potential future applications and challenges, offering valuable insights for the development of next-generation flexible transparent electrodes.

24 June 2025 in Preprints.org
Verified
Preprint
Open access
PDF file
JLJi Li
Ji Li
JLJun Luo
Jun Luo
YLYang Liu
Yang Liu
Silver nanowires (AgNWs)-based transparent conductive films are critical for flexible electronics due to their excellent optoelectronic properties and mechanical flexibility. We discussed the preparation methods of AgNWs films, including Mayer rod coating, spray coating, spin coating, screen printing, and inkjet printing, and analyzed their advantages, limitations, and applicable scenarios. Furthermore, we systematically explored anti-oxidation strategies for AgNWs, such as surface modification, composite structure design, and process optimization. Potential approaches to enhance the conductivity, transparency, and flexibility of AgNWs films were also outlined. Finally, we discussed future applications and challenges, offering insights for the development of next-generation flexible transparent electrodes.

7 January 2026 in Materials
Verified
Journal Article
Open access
PDF file
GLGeng Li
Geng Li
TYTengyi Yu
Tengyi Yu
PYPeiqing Yang
Peiqing Yang
SZSuning Zhao
Suning Zhao
SZShuai Zhang
Shuai Zhang
MGMing Gao
Ming Gao
The adjustable-ring-mode (ARM) scanning laser was used to perform butt welding on 0.5 mm thick TA1 titanium alloy and 304 stainless steel (SS304) thin sheets, with 1.2 mm diameter AZ61S magnesium alloy welding wire as the filling material. Microhardness test results show that the hardness distribution presented a trend of being higher in the base metals on both sides and lower in the middle filling area, with no hardening observed in the weld zone. For all specimens subjected to horizontal and axial weld bending tests, the bending angle reached 108° without any cracks occurring. When the ring power was in the range of 800–1000 W, or the scanning frequency was between 100 and 200 Hz, all the average tensile strengths of the welded joints were more than 80% of that of the AZ61S filling material (approximately 240 MPa); the maximum average tensile strength stood at 281.2 MPa, which is equivalent to 93.7% of the AZ61S. As the ring power or scanning frequency increased further, the tensile strengths of the joints showed a decreasing trend. The remelting effect of the trailing edge of the ARM laser under high energy conditions, or the scouring of the turbulent molten flow induced by the scanning beam, damages the weak links at the newly formed solid–liquid interface and increases the Fe concentration in the molten pool. This leads to a thicker FeAl interface layer during growth, thereby resulting in a decline in the mechanical properties of the welded joints.