We examined an environmentally friendly photoresist removal method using radicals produced by decomposing mixtures of hydrogen and oxygen on a hot tungsten catalyst. The photoresist removal rate increased with the oxygen additive amount (the flow rate ratio of oxygen to hydrogen) up to an optimal amount and then decreased gradually. When the catalyst temperature was 1600 °C, the optimal oxygen additive amount was 1.0% and the removal rate was 1.7 times higher than that in the pure hydrogen system. At 2000 °C, the optimal amount increased to 2.5% but the increase ratio decreased by 1.3 times. At high catalyst temperatures, the absolute removal rate as well as the optimal oxygen additive amount is high, but the increase ratio is low. At the optimal oxygen additive amount, H, O, and OH radicals may exert their effects together to decompose photosensitive polymers.
4 October 2008 in Journal of the American Chemical Society
The angle-resolved Si 2p photoelectron spectra arising from a interfacial transition layer formed on a Si(100) were measured with a probing depth of nearly 2 nm. The novel analytical procedure of these spectra was developed by considering that one SiO2monolayer, two compositional transition layers (CTLs), and one Si monolayer constituting the Si substrate surface are continuously connected with each other to maintain the areal density of Si atoms. It was found for thermally grown transition layers that two CTLs are formed on the oxide side of the CTL/Si interface and the chemical structures correlated with the residual stress appear on the Si substrate side of the interface. The effects of oxidation temperature in the range from 900 to 1050 °C, annealing in the forming gas, and oxidation using oxygen radicals on the chemical structures of transition layers formed on both sides of the interface were also clarified.
25 June 2018 in Journal of Photopolymer Science and Technology
Photoresist removal method using hydrogen radicals, which are produced on a tungsten hot-wire catalyst, is effective to resolve some environmental and industrial problems in conventional methods for the fabrication of electronic devices. However, its removal rate is not as good as that of the conventional ones. We have previously described that the removal rate of a positive-tone novolac photoresist is enhanced by the addition of a small amount of oxygen gas to the atmosphere, in which hydrogen radicals are produced. Oxidizing radicals, such as OH and O radicals, can be produced together with H radicals. In present study, we examined the effects of oxygen addition on base polymers of KrF and ArF photoresists: the former is poly(vinyl phenol) (PVP), and the latter is poly(methyl methacrylate) (PMMA). Effects of oxygen addition on PVP was confirmed, as was found for the novolac photoresist. On the other hand, the effects on PMMA were different from the cases of the novolac photoresist and PVP. Results were ascribed to the presence or absence of benzene rings, the properties of polymers and the reactivity of oxidizing radicals.