A PbS quantum dots (QDs) fiber amplifier was fabricated and characterized by using a standard single mode fiber (SMF) coupler. The fiber amplifier was fabricated by coating PbS QDs doped sol-gel films onto the tapered SMF coupler. Through the evanescent wave, the PbS quantum dots were excited. With a 980 nm wavelength laser diode (LD) as the pump, the fiber amplifier exhibited a wide band optical gain at 1310 nm with the largest gain as high as 10 dB. The amplified spontaneous emission (ASE) noise is very low resulted from the amplifier configuration of evanescent wave exciting, which is critical to improve the signal-to-noise ratio. Therefore the proposed fiber amplifier will find great potential in the fiber-optic communication systems.
There have been few reports on polymerization-induced self-assembly of poly(ionic liquid)-based block copolymers, with limited access to higher order morphologies. Herein, a full range of morphologies including spheres, worms, and vesicles is readily synthesized via RAFT ethanolic dispersion polymerization of 1-butyl-3-(4-vinylbenzyl) imidazolium tetrafluoroborate to generate poly(N,N-dimethylacrylamide)-b-poly(ionic liquid) nano-objects.
Optical fiber amplifiers based on PbS/CdS semiconductor quantum dots (QDs) modified by an amphiphilic polymer were demonstrated. Well-defined QDs and an amphiphilic copolymer were first prepared and the amphiphilic copolymer was then used to disperse the QDs into silica sol to allow uniform and reproducible incorporation of QDs into the silica coating of the optical fibers. QD-doped silica sol was deposited on the fusion tapered fiber coupler via dip-coating. A 1550 nm semiconductor light emitting diode as the signal source and a 980 nm laser diode as the pump source were injected into the fiber coupler simultaneously. Through evanescent wave excitation, a signal gain as high as 8 dB was obtained within the wavelength range between 1450 and 1650 nm. In addition, the optical fiber amplifiers based on PbS/CdS QDs showed enhanced thermal stability when compared to amplifiers based on PbS QDs.
Poor thermal stability has remained a severe obstacle for practical applications of optical fiber amplifiers based on quantum dots (QDs). We demonstrate that thermal stability at elevated temperatures can be achieved by using oleic-acid-capped QDs. Optical fiber amplifiers using oleic-acid-capped QDs for the gain medium exhibited stable gain of more than 5 dB at 1550 nm between 25 °C and 50 °C that did not degrade upon cooling. In contrast, fiber amplifiers employing oleylamine-capped QDs exhibited reduced gain when heated and subsequently cooled.
We demonstrate a high-energy noise-like pulse (NLP) generated by an Er-doped fiber (EDF) laser incorporating a PbS quantum dot (QD) polystyrene (PS) composite film as a saturable absorber (SA). Benefitting from the intrinsic properties of NLPs and the high damage threshold of the PbS QD PS composite film, a stable NLP train can be obtained with an output power of 96.3 mW at a pump power of 660 mW, corresponding to a pulse energy of 9.68 nJ. This represents the highest pulse energy ever reported in an NLP EDF laser incorporating material-based SAs. The slope efficiency reached 17.37% and the steady NLP operation was able to be maintained for several hours under laboratory conditions. Our experimental results prove that the PbS QD PS composite film can serve as an effective SA to realize high-energy pulses in a mode-locked fiber laser.