As infrastructure and populations are highly condensed in megacities, urban flood management has become a significant issue because of the potentially severe loss of lives and properties. In the megacities, rainfall from the catchment must be discharged throughout the stormwater pipe networks of which the travel time is less than one hour because of the high impervious rate. For a more accurate calculation of runoff from the urban catchment, hourly or even sub-hourly (minute) rainfall data must be applied. However, the available data often fail to meet the hydrologic system requirements. Many studies have been conducted to disaggregate time-series data while preserving distributional statistics from observed data. The K-nearest neighbor resampling (KNNR) method is a useful application of the nonparametric disaggregation technique. However, it is not easy to apply in the disaggregation of daily rainfall data into hourly while preserving statistical properties and boundary continuity. Therefore, in this study, three-day rainfall patterns were proposed to improve reproducible ability of statistics. Disaggregated rainfall was resampled only from a group having the same three-day rainfall patterns. To show the applicability of the proposed disaggregation method, probability distribution and L-moment statistics were compared. The proposed KNNR method with three-day rainfall patterns reproduced better the characteristics of rainfall event such as event duration, inter-event time, and toral amount of rainfall event. To calculate runoff from urban catchment, rainfall event is more important than hourly rainfall depth itself. Therefore, the proposed stochastic disaggregation method is useful to hydrologic analysis, particularly in rainfall disaggregation.
In mega cities such as Seoul in South Korea, it is very important to protect the cities from surface flooding even for a short time period due to the enormous economic damage. That is why stormwater pipe networks are commonly applied to mega cities with large impervious areas to drain runoff from the city. Therefore, the stormwater pipe networks in urban catchments should be carefully designed for quick and efficient runoff removal. In this study, the structures of different stormwater pipe networks were evaluated based on the relationship between peak rainfall and runoff in the urban catchments in South Korea. More than 400 historical rainfall events from five urban catchments were used to develop respective linear regression models for estimating peak runoff for different pipe network structures. The developed regression models exhibited greater than 0.9 in determination coefficients and demonstrated overall the broader ranges in peak runoff with the greater rainfall amount, especially when the pipe networks were branched. This implies that the effect of pipe network structures on runoff is more profound in the branched networks whose runoff water flow is one-directional and thus tends to concentrate to the catchment outlet. In the case of the looped networks in which runoff paths are multiple, rainfall runoff can be routed to several alternative water paths depending on rainfall events resulting in the reduced peak runoff. The structures of pipe networks can be measured in drainage density which is defined as the ratio of total pipe length to catchment area. As a result, the range of the estimated runoff at the 95% confidence level increased as the drainage density increased, which implies increased uncertainty with the looped networks which commonly involve more pipe installation for unit area as compared to the branched. However, the looped networks with multiple water paths can reduce the time to drain rainfall from the catchments and thus the 95% confidence interval becomes narrow, which means greater reliability in peak runoff estimation. It would therefore be favorable to adopt looped stormwater pipe networks within an affordable budget and the complexity of pipe networks needs to be counted to reduce urban flood risk.
Recently, climate change has increased the frequency of extreme weather events. In South Korea, extreme droughts are frequent and cause serious damage. To identify the risk of extreme drought, we need to calculate the hydrologic risk using probabilistic analysis methods. In particular, future hydrologic risk of extreme drought should be compared to that of the control period. Therefore, this study quantitatively assessed the future hydrologic risk of extreme drought in South Korea according to climate change scenarios based on the representative concentration pathway (RCP) 8.5. A threshold level method was applied to observation-based rainfall data and climate change scenario-based future rainfall data to identify drought events and extract drought characteristics. A bivariate frequency analysis was then performed to estimate the return period considering both duration and severity. The estimated return periods were used to calculate and compare hydrologic risks between the control period and the future. Results indicate that the average duration of drought events for the future was similar with that for the control period, however, the average severity increased in most future scenarios. In addition, there was decreased risk of maximum drought events in the Yeongsan River basin in the future, while there was increased risk in the Nakdong River basin. The median of risk of extreme drought in the future was calculated to be larger than that of the maximum drought in the control period.
1 November 2015 in KSCE Journal of Civil Engineering
In this study, optimal water quality sensor placement is performed based on the sensitivity of flow direction under different water demands for detecting accidental water quality contamination. First, Betweenness Centrality (BC), a network analysis method, is used for determining optimal locations considering a network’s connectivity. Second, sensor locations are optimized for minimizing the contaminant intrusion detection time using the travel time matrix and the Multi-Objective Genetic Algorithm (MOGA). These methods were applied to two water distribution networks. It was found that the BC method generates optimal locations close to the water sources and the water main, whereas the MOGA-based method generates optimal sensor locations far away from the sources. These results support the following conclusions. First, the installation priority of gauges can be determined with a more objective standard using the aforementioned two methods. Second, given specific objectives, the two models can be used as alternative decision-making tools for sensor installation.
30 April 2014 in Journal of the Korean Society of Hazard Mitigation