It is difficult to quantify the timing of the deformation processes in brittle fold–thrust belts because minerals suitable for dating and well-preserved growth strata sediments are scarce or absent. Here, we quantify the duration of thrust sheet emplacement and shortening rates in the SE Pyrenean thrust sequence using U–Pb dating of fracture-filling calcites. The obtained U–Pb dates reveal a minimum duration for the emplacement of each thrust unit (18.7 Ma for the Bóixols–Upper Pedraforca, 11.6 Ma for the Lower Pedraforca and 14.3 Ma for the Cadí thrust sheets) and show that piggy-back thrusting was accompanied by post-emplacement deformation of the upper thrust sheets above the lower sheets during their south-directed tectonic transport. We calculated shortening rates of 0.6, 3.1 and 1.1 mm a ⁻¹ from the older to younger emplaced thrust sheets. Our results also reveal the formation of local normal faults during the late Oligocene as a result of the late stages of compression and exhumation in the SE Pyrenees. We observed that temperatures >110 °C could be a limiting factor when applying the U–Pb dating method. Supplementary material: U-Pb analytical results, concordia plots and fracture data are available at https://doi.org/10.6084/m9.figshare.c.5078862

Deformation in intraplate domains is usually considered as a consequence of tectonic events at plate boundaries. Nevertheless, the occurrence of intraplate earthquakes such as the recent Le Teil event in the south of France along the Cévennes Fault System (CFS), on 11 November 2019, Mw = 4.9, questions whether this far-field deformation only occurs during tectonic pulses at plate boundaries, or if it corresponds to low-intensity but regional continuous deformation through time. To address this question, we have coupled U–Pb geochronology of fault-related calcites with structural analysis along a major fault system (the CFS) in the South-East Basin, France. We evidence (1) an Albian activity of the CFS and (2) a continuous compressional activity of the CFS and satellite structures during the whole Eocene and probably during the Late Cretaceous – Palaeocene, including periods (e.g. Lutetian) usually considered as phases of tectonic quiescence. We thus demonstrate that the tectonic reactivation of this intraplate fault system is not restricted to periods of high rates of deformation at plate boundaries.

In the Kiggavik area (Nunavut, Canada), major fault zones along, or close to, where uranium deposits are found are often associated with occurrence of thick quartz breccia (QB) bodies. These bodies formed in an early stage (~1750 Ma) of the long-lasting tectonic history of the Archean basement, and of the Proterozoic Thelon basin. The main characteristics of the QB are addressed in this study; through field work, macro and microscopic observations, cathodoluminescence microscopy, trace elements, and oxygen isotopic signatures of the quartz forming the QB. Faults formed earlier during syn- to post-orogenic rifting (1850–1750 Ma) were subsequently reactivated, and underwent cycles of cataclasis, pervasive silicification, hydraulic brecciation, and quartz recrystallization. This was synchronous with the circulation of meteoric fluids mixing with Si-rich magmatic-derived fluids at depth, and were coeval with the emplacement of the Kivalliq igneous suite at 1750 Ma. These processes led to the emplacement of up to 30 m thick QB, which behaved as a mechanically strong, transverse hydraulic barrier that localized later fracturing, and compartmentalized/channelized vertical flow of uranium-bearing fluids after the deposition of the Thelon Basin (post 1750 Ma). The development and locations of QB control the location of uranium mineralization in the Kiggavik area.

Structural, petrological and geochemical (δ¹³C, δ¹⁸O, clumped isotopes, ⁸⁷Sr/⁸⁶Sr and ICP-MS) analyses of fracture-related calcite cements and host rocks are used to establish a fluid-flow evolution model for the frontal part of the Bóixols thrust sheet (Southern Pyrenees). Five fracture events associated with the growth of the thrust-related Bóixols anticline and Coll de Nargó syncline during the Alpine orogeny are distinguished. These fractures were cemented with four generations of calcite cements, revealing that such structures allowed the migration of different marine and meteoric fluids through time. During the early contraction stage, Lower Cretaceous seawater circulated and precipitated calcite cement Cc1, whereas during the main folding stage, the system opened to meteoric waters, which mixed with the connate seawater and precipitated calcite cement Cc2. Afterwards, during the post-folding stages, connate evaporated marine fluids circulated through newly formed NW-SE and NE-SW conjugate fractures and later through strike-slip faults and precipitated calcite cements Cc3 and Cc4. The overall paragenetic sequence reveals the progressive dewatering of Cretaceous marine host sediments during progressive burial, deformation and fold tightening and the input of meteoric waters only during the main folding stage. This study illustrates the changes of fracture systems and the associated fluid-flow regimes during the evolution of fault-associated folds during orogenic growth.