With the depletion of river sand and the rapid expansion of marine infrastructure, seawater–sea-sand concrete (SSC) has attracted increasing attention due to its low cost and sustainability. However, the high chloride content in SSC accelerates steel corrosion. This significantly limits its use in conventional reinforced concrete structures. In recent years, the rise in FRP–steel composite confinement has offered a new solution to this durability bottleneck. Based on this background, scholars have proposed a new type of FRP–steel composite tube confined seawater–sea-sand concrete (FCTSSC) column. This paper reviews the research progress on SSC, CFST, FCFST, and FCTSSC. The latter systems are developed based on the former. The results show that advanced FCTSSC columns exhibit strong synergistic confinement between the FRP and the steel tube when compared with CFST and FCFST. This synergy enhances the bearing capacity, ductility, and post-peak behavior of SSC. Both external and internal FRP configurations can reduce the brittleness and expansion of SSC. They also effectively restrain local buckling of the steel tube. Existing studies mainly focus on short columns. Research on intermediate slender and slender columns remains limited. This includes structural behavior, rational design models, and long-term durability. Finally, future research directions are proposed to support the practical application of FCTSSC in marine engineering.
This study develops a capacity-equivalent framework for selecting circular, square, and rectangular deep cement mixing (DCM) columns for a soft-soil bridge foundation when pier load varies in service. Unlike equal-length shape comparisons, the required column length was determined separately for each geometry and area replacement ratio under the same 240 kN bearing-capacity criterion. Sixty-three three-dimensional ABAQUS cases covered replacement ratios from 0.30 to 0.50; selected circular and rectangular cases were then evaluated at five loads from 180 to 240 kN. The model used Mohr-Coulomb soil and linear-elastic DCM and cushion idealizations and was checked against a layered-summation solution and one field settlement measurement at 196 kN. The finite-element settlement differed by 3.4% from the analytical value and by 14.5% from the field measurement. At m = 0.30, circular, square, and rectangular configurations produced settlements of 25.44, 27.78, and 32.41 mm, respectively; the rectangular configuration used the least cement-treated soil (3.60 m³). Increasing m generally shortened the design-dependent column and reduced equivalent-stress demand but increased cement-treated volume, so settlement did not change monotonically. Range-averaged normalized settlement sensitivities were 0.454 and 1.109 for the circular and rectangular cases, while the corresponding equivalent-stress sensitivities were 0.877 and 0.638. The framework shows that capacity compliance, settlement, relative stress demand, material use, and load adaptability can favor different geometries. The findings remain site- and model-specific because groundwater, consolidation, nonlinear DCM behavior, and full mesh and boundary sensitivity studies were not included.