Green and low-carbon filling materials, primarily composed of dredged waste fills, are commonly used in the foundation of coastal highways. These materials possess high water content and under-consolidation characteristics, which can lead to differential settlement between piles and the surrounding environment. However, mechanical models of negative friction in piles within recycled dredged waste fills are insufficiently developed and presented. A mechanical model for the negative friction of a single pile in a composite foundation, consisting of dredged waste fills and other materials, is established based on the load transfer method. Through centrifugal model testing and numerical simulations, the development of negative friction and the migration pattern of the neutral point are analyzed and clarified. The results show that the theoretical model based on improved transfer function can effectively predict the neutral point position and negative friction value (average relative error < 6.5%). The theoretical analysis and experimental results indicate that the downward load due to negative friction increases nonlinearly. The loading strength exhibits a clear relationship with the consolidation process. Additionally, the dynamic evolution of the neutral point position is strongly correlated with consolidation of dredged fills. The size of pile foundation significantly influences the distribution of negative friction. Results show that the increment in negative friction for a pile with a 1.05 m diameter is 7.3% higher than that for a pile with a 1.5 m diameter. Smaller-diameter piles are more susceptible to negative friction due to the higher friction strength per unit area. The negative frictional resistance will enter a stable period after 50 months of settlement. The investigation can provide significant references for the design of pile foundations in areas with reclaimed materials, improving the stability and safety of pile foundations in practical engineering.

Based on the G85 high-fill subgrade project in east Gansu Province, this study conducts one-dimensional compression tests in the laboratory on both disturbed and in situ-compacted loess. Through the combination of the test results of remolded soil, compaction standards for each layer of the subgrade fill are established, and quality inspections of the compacted subgrade are performed. The experimental results demonstrate that the compression deformation of remolded loess exhibits a positive correlation with compaction degree and a negative correlation with moisture content. Under constant compaction degree conditions, axial pressure and deformation follow a linear relationship, whereas under fixed conditions, the relationship adheres to a quadratic trend. Specimen void ratios show minimal variation within the 25–100 kPa stress range but undergo significant reduction between 100 and 400 kPa. Under an axial compressive load of 100–200 kPa, the compression coefficient at a height of 10 m within the subgrade ranges from 0.163 to 0.171 MPa⁻¹. At a height of 6 m, it ranges from 0.177 to 0.183 MPa⁻¹, and at 1 m, from 0.183 to 0.186 MPa⁻¹. These values indicate that the compaction quality throughout the subgrade corresponds to a low compressibility level. However, the compaction quality near the slopes on both sides is slightly lower than that along the centerline of the subgrade. Overall, the compaction quality meets the required standards.