In this study, in-situ electroplating method was used to fabricate a metal joint fixed extrinsic Fabry-Perot interferometric (EFPI) sensor. Specifically, optical fibers were firstly chemical plated with a very thin conductive nickel layer and then electroplated with nickel coating. After that, in-situ electroplating method was used to fix the metallized optical fibers and the capillary steel tube, the reflection spectra changes of the EFPI sensors during the in-situ electroplating process were recorded in real time, and the temperature sensing characteristics of the EFPI sensors were studied assisted by the temperature sensing system. Results show that: (i) optical fibers are well protected by the nickel layer; (ii) the reflection spectra of the EFPI sensors are clear and complete in the whole in-situ electroplating process, it is feasible to fabricate a EFPI sensor with the in-situ electroplating method; (iii) with the increases of temperature, the peak numbers of the reflection spectra of the EFPI sensors increase gradually; (iv) the EFPI sensors with different cavity length based on the in-situ electroplating method show excellent sensing characteristics, the temperature sensitivities reach up to about 700, 600, and 400 pm/°C from room temperature to 400 °C, respectively.
This study investigates the effects of ultrasonic surface rolling process (USRP) parameters—static load, indentation depth—on the surface integrity, mechanical properties, and high-temperature oxidation properties of laser-clad NiCrAl coatings. Comprehensive experimental results demonstrate that USRP treatment effectively eliminates surface cracks and significantly enhances surface integrity. The process simultaneously improves mechanical properties, with microhardness increasing by 24.6% due to grain refinement-induced strengthening and elevated dislocation density. Under constant preload, increasing the ultrasonic rolling indentation depth effectively transforms residual tensile stress into beneficial compressive stress (from +69.8 MPa to −1315.3 MPa), with higher preload further enhancing this effect. Moreover, USRP-treated coatings achieve complete oxidation resistance at elevated temperatures by forming a denser and more continuous oxide layer while effectively suppressing internal oxidation, resulting in markedly improved high-temperature oxidation performance. Quantitative analysis confirms that the enhancement in surface mechanical properties is primarily attributed to microstructural refinement and dislocation strengthening mechanisms.