Additive manufacturing (AM), particularly fused filament fabrication (FFF), has gained significant attention for its design flexibility and cost-effectiveness. This study focuses on optimizing FFF parameters that employ response surface methodology (RSM) to enhance the flexural performance of polyethylene terephthalate glycol (PETG) parts. Three essential parameters—layer height, print speed, and nozzle temperature—were varied, and their effects on flexural strength, flexural modulus, flexural toughness for ultimate strength, flexural toughness at 5% strain, and strain at ultimate strength were evaluated. Based on a Box–Behnken design, the experiments revealed significant effects of these parameters on the mechanical responses. The analysis of variance (ANOVA) indicates that layer height predominantly affects flexural modulus and toughness, while nozzle temperature significantly impacts flexural strength. The RSM models exhibited high accuracy, with R2 values exceeding 99%. Optimal parameter combinations yield remarkable improvements: flexural strength reached 39.55 MPa, flexural modulus peaked at 1344.60 MPa, flexural toughness for ultimate strength reached 218.22 J/mm3, flexural toughness at 5% strain reached 381.47 J/mm3, and strain at ultimate strength reached 3.50%. Validation experiments confirm the effectiveness of the optimization, with errors below 3.17%.
Lightweight PLA (LW-PLA) filaments enable material-saving designs in fused filament fabrication (FFF), yet optimizing their mechanical performance remains challenging due to temperature-sensitive foaming behavior. This study aims to enhance the structural strength and material efficiency of LW-PLA parts using a multi-objective statistical approach. Four key process parameters—infill density (Id), material flow rate (Mf), wall line count (Wlc), and infill pattern (Ip)—were systematically varied using a Taguchi L16 orthogonal array. Tensile strength (Ts), flexural strength (Fs), and material consumption (Mc) were selected as the critical response metrics. Grey Relational Analysis (GRA) was used to aggregate these responses into a single performance index, and ANOVA determined each factor’s contribution. The optimal combination of 60% infill density, 70% material flow, 4 wall lines, and line infill pattern yielded a 9.02% improvement in the overall performance index compared to the baseline, with corresponding Ts and Fs values of 13.58 MPa and 20.51 MPa. Mf and Wlc were the most influential parameters on mechanical behavior, while Id mainly affected Mc. These findings confirm that integrating Taguchi and GRA enables effective parameter tuning for LW-PLA, balancing strength and efficiency. This work contributes to the development of lightweight, high-performance parts suitable for functional applications such as UAVs and prototyping.
24 August 2020 in Journal of the Brazilian Society of Mechanical Sciences and Engineering