To extend the service life of 316L stainless steel components in harsh environments, this study utilized laser cladding technology to enhance the hardness, wear resistance, and corrosion resistance of the 316L stainless steel surface. Nickel-based and cobalt-based cladding layers were prepared on the surface of the 316L stainless steel, and the microstructure and phases of the layers were analyzed using scanning electron microscopy, energy dispersive spectroscopy, X-ray diffraction, and X-ray photoelectron spectroscopy. In addition, the hardness of the substrate and the cladding layers was tested with a microhardness tester, the frictional wear performance was tested with a pin on disc wear tester, and the corrosion resistance was tested with an electrochemical workstation. The experimental results indicate that the nickel-based cladding layer primarily comprises the γ-(Fe, Ni), Cr₇C₃, and Ni₃Si phases, with equiaxed and dendritic grains being the predominant morphologies. By contrast, the cobalt-based cladding layer mainly comprises the γ-Co, Cr₇C₃, and Co₇W₆ phases, with columnar and dendritic grains being the predominant morphologies. Both cladding layers displayed a significantly better microhardness, wear resistance, and corrosion resistance than the substrate. Between the two cladding layers, the nickel-based cladding layer demonstrated a superior microhardness, whereas the cobalt-based cladding layer slightly outperformed in wear resistance and corrosion resistance. The findings from our results are important for understanding the performance of laser-cladding layers and laying a scientific basis for the promotion and optimization of laser cladding technology in industrial applications. Moreover, our results showed that laser cladding technology is increasingly important in extending the service life of components and improving the material performance.

Despite extensive research on the effect of nitrogen flow rate on titanium nitride (TiN) coating properties, its influence on esthetic and engineering performance through microstructure control remains insufficiently explored. To simultaneously meet the requirements for surface strengthening and decorative esthetics in high-end stainless-steel crafts, TiN coatings were deposited on 304L stainless-steel substrates using multi-arc ion plating. The regulatory mechanisms and synergistic evolution laws of nitrogen flow rates (100, 200, and 300 sccm) on the microstructure, decorative properties (color and gloss), and engineering performance (adhesion strength, hardness, wear resistance, and corrosion resistance) of the coatings were investigated. At a nitrogen flow rate of 200 sccm, the coating exhibited a uniform and dense columnar crystal structure, as well as a saturated golden hue with high surface gloss. Additionally, the film–substrate adhesion, microhardness, tribological properties, and corrosion resistance reached optimal levels. In contrast, excessively low (100 sccm) or high (300 sccm) nitrogen flow rates resulted in coarse particles and blurred grain boundaries owing to uncontrolled droplet ejection or target poisoning, respectively, thereby deteriorating both appearance and engineering performance. These findings can inform the optimization of TiN coatings, enabling the design of surfaces that simultaneously meet esthetic and high-performance engineering requirements.

In our investigation of the influence rules and mechanisms of the building orientation on the surface properties of 316L stainless steel created via selective laser melting, we used X-ray diffractometry, scanning electron microscopy, and electron backscatter diffraction to investigate the phases, microstructures, and textures of specimens. In addition, we employed a digital microhardness tester, friction, and wear-testing apparatus, along with an electrochemical workstation, to examine variations in the surface properties. The results indicated that the surface phase compositions of the specimens with different building orientations were similar; however, they displayed anisotropic behavior in grain size, orientation, and texture. Notably, the surface densification of the specimens at 0°, 30°, 45°, and 60° initially decreased before subsequently increasing. In contrast, the surface roughness showed a pattern of first increasing and then declining. Moreover, the microhardness, wear resistance, and corrosion resistance decreased with an increasing inclination angle.