Pengfei Liu

Dr. Pengfei Liu


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 October 2025 in Symmetry
Verified
Journal Article
Open access
PDF file
PLPengfei Liu
Pengfei Liu
SYShuairan Yu
Shuairan Yu
RZRuiyang Zhang
Ruiyang Zhang
YCYanMing Cheng
YanMing Cheng
SYShaojie Yu
Shaojie Yu
The dead-time effect seriously affects the soft-switching performance and operating efficiency of the dual-active-bridge converter, and also causes problems such as reduced duty cycle, distortion of voltage and current waveforms, and narrowed transmission power range. The proposal of the five-degree-of-freedom modulation strategy transforms the working voltage waveforms of the primary and secondary sides as well as the inductor current waveform of the DAB converter from symmetric to asymmetric, while the dead-time issue still persists. Based on the five-degree-of-freedom modulation strategy, this paper analyzes the electrical characteristics of the converter before and after the introduction of dead time, designs switch drive pulses to avoid the dead time, and proposes a dead-time compensation modulation strategy based on five-degree-of-freedom phase shift. The results show that the proposed dead-time compensation control strategy can avoid problems such as voltage and current waveform distortion and reduction in the soft-switching power range caused by dead time, realizing dead-time compensation in the full power range. Experimental measurements show that, for different voltage transmission ratios, the maximum efficiency improvement is approximately 3.8–4% and the current stress is reduced by 2.11% to 3.13% under low-power operating conditions. The maximum efficiency improvement is approximately about 1.4–2.8% and the current stress is reduced by 1.84% to 2.53% under high-power operating conditions.

7 May 2025 in Symmetry
Verified
Journal Article
Open access
PDF file
XBXinwen Bi
Xinwen Bi
SYShuairan Yu
Shuairan Yu
PLPengfei Liu
Pengfei Liu
YCYanMing Cheng
YanMing Cheng
This paper presents an enhanced bipolar control strategy for 400 Hz three-phase inverters in aviation ground power supplies, with a focus on maintaining symmetry in power output under unbalanced load conditions. The strategy integrates Linear Active Disturbance Rejection Control (LADRC) for robust positive sequence voltage regulation, Proportional Integral with repetitive control (PI + RC) for harmonic suppression in positive sequence currents, and a Quasi-Proportional Resonance (QPR) controller for negative sequence components in the static coordinate system. By doing so, it simplifies negative sequence control and combines PI + RC to improve the dynamic response and eliminate periodic errors. In the context of symmetry, the proposed strategy effectively reduces the total harmonic distortion (THD) and the three-phase current imbalance degree. Simulation results show significant improvements: under balanced loads, THD is reduced by 41.5% (from 1.95% to 1.14%) compared to traditional PI control; under single-phase and three-phase unbalanced loads, THD decreases by 52.7% (2.56% to 1.21%) and 48.1% (2.39% to 1.24%), respectively. The system’s settling time during load transients is shortened by over 30%, and the three-phase current imbalance degree is reduced by 60–70%, which validates the strategy’s effectiveness in enhancing power quality and system stability, thus restoring and maintaining the symmetry of the power output.

7 November 2025 in Electronics
Verified
Journal Article
Open access
PDF file
YCYanMing Cheng
YanMing Cheng
SYShaojie Yu
Shaojie Yu
XZXiaodan Zhang
Xiaodan Zhang
RZRuiyang Zhang
Ruiyang Zhang
PLPengfei Liu
Pengfei Liu
SYShuairan Yu
Shuairan Yu
In this paper, an efficient magnetic coupler featuring tight coupling and precise alignment is proposed for unmanned aerial vehicle (UAV) wireless charging systems. The design integrates ArUco markers for accurate landing guidance, a position-limiting guide groove to facilitate mechanical alignment, and a dual-coil tightly coupled configuration to significantly enhance charging efficiency. Specifically, the dual-coil structure is carefully optimized to maximize magnetic coupling and energy transfer performance. Additionally, an improved electromagnetic shielding structure is implemented to reduce electromagnetic leakage and further improve system efficiency. A suitable wireless charging circuit topology is then designed and thoroughly analyzed to match the proposed magnetic coupler, enabling constant-voltage charging operation. The performance of the system is validated through both finite element simulations using ANSYS Maxwell and experimental testing on a prototype setup. Results demonstrate that the integration of ArUco-based visual guidance with the mechanical alignment mechanism achieves a landing deviation of ±12.5 mm without requiring auxiliary positioning components, thereby simplifying system architecture. Under the tightly coupled configuration, the proposed system delivers 78.8 W of charging power to a UAV with a peak efficiency of 95.93%, confirming its effectiveness and high performance.