Due to their high strength-to-weight ratio and corrosion resistance, glass fiber reinforced polymer (GFRP) composites have been used in various civil structures. However, the GFRP profiles may be perforated to allow bolting, wiring, and pipelining, causing stress concentration and safety concerns in load-carrying scenarios. A fundamental understanding of the stress concentration mechanisms and the efficacy of mitigation techniques in such anisotropic materials remains limited, particularly for the complex stress states introduced by perforations and mechanical fasteners. This study investigates the effectiveness of three techniques, adhesive filling, bolt reinforcement, and elliptical perforation design, in mitigating stress concentration and enhancing the strength of perforated GFRP plates. The effects of perforation geometry, filler modulus, bolt types, and applied preloads on the stress concentration and bearing capacity are investigated through experimental and finite element analysis. The results reveal that steel bolt reinforcement significantly improves load-bearing capacity, achieving a 13.9% increase in the pultrusion direction and restoring nearly full strength in the transverse direction (4.91 kN vs. unperforated 4.89 kN). Adhesive filling shows limited effectiveness, with minimal load improvement, while elliptical perforations exhibit the lowest performance, reducing strength by 38% compared to circular holes. Stress concentration factors (SCF) vary with hole diameter, peaking at 5.13 for 8 mm holes in the pultrusion direction, and demonstrate distinct sensitivity to filler modulus, with optimal SCF reduction observed at 30–40 GPa. The findings highlight the anisotropic nature of GFRP, emphasizing the importance of reinforcement selection based on loading direction and structural requirements. This study provides critical insights for optimizing perforated GFRP components in modular construction and other civil engineering applications.
Asphalt pavements incorporating recycled and sustainable materials have become a widely adopted strategy in road construction, particularly with the use of reclaimed asphalt pavement (RAP) and crumb rubber (CR) derived from waste tires. However, the adhesion and cohesion characteristics of rubberized RAP mixtures remain insufficiently understood. This study investigates how interfacial bonding affects the rutting resistance and moisture susceptibility of rubberized RAP asphalt mixtures. Two RAP sources with different aging levels and two CR particle sizes (250 μm and 380 μm) were evaluated. Binder bond strength (BBS) tests showed that pull-off strength increased with the use of smaller CR particles and more highly aged RAP, while rotational viscosity and penetration tests confirmed the corresponding increase in binder stiffness. Hamburg wheel track (HWT) tests with high-temperature viscoplastic deformation analysis demonstrated improved rutting resistance in the tested mixtures. Furthermore, boiling tests supported by image analysis revealed reductions in stripping ratios, indicating enhanced moisture resistance. ANOVA results (p < 0.05) confirmed that CR content had a significant effect on bonding characteristics, whereas RAP aging and CR particle size jointly influenced rutting performance. Overall, mixtures incorporating 10% CR and 25% RAP achieved the best balance between adhesion, cohesion, and durability. These findings provide a quantitative understanding of how interfacial bonding governs the mechanical performance and moisture resistance of rubberized RAP mixtures.
29 October 2025 in Journal of Wuhan University of Technology-Mater. Sci. Ed.