Chao Yu

Mr. Chao Yu


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 September 2025 in Materials
Verified
Journal Article
Open access
PDF file
Yiqing DaiYiqing Dai
Yiqing Dai
JCJiachun Chen
Jiachun Chen
CYChao Yu
Chao Yu
AAAhmed D. Almutairi
Ahmed D. Almutairi
YYYan Yuan
Yan Yuan
Due to their high strength-to-weight ratio and corrosion resistance, glass fiber reinforced polymer (GFRP) composites have been used in various civil structures. However, the GFRP profiles may be perforated to allow bolting, wiring, and pipelining, causing stress concentration and safety concerns in load-carrying scenarios. A fundamental understanding of the stress concentration mechanisms and the efficacy of mitigation techniques in such anisotropic materials remains limited, particularly for the complex stress states introduced by perforations and mechanical fasteners. This study investigates the effectiveness of three techniques, adhesive filling, bolt reinforcement, and elliptical perforation design, in mitigating stress concentration and enhancing the strength of perforated GFRP plates. The effects of perforation geometry, filler modulus, bolt types, and applied preloads on the stress concentration and bearing capacity are investigated through experimental and finite element analysis. The results reveal that steel bolt reinforcement significantly improves load-bearing capacity, achieving a 13.9% increase in the pultrusion direction and restoring nearly full strength in the transverse direction (4.91 kN vs. unperforated 4.89 kN). Adhesive filling shows limited effectiveness, with minimal load improvement, while elliptical perforations exhibit the lowest performance, reducing strength by 38% compared to circular holes. Stress concentration factors (SCF) vary with hole diameter, peaking at 5.13 for 8 mm holes in the pultrusion direction, and demonstrate distinct sensitivity to filler modulus, with optimal SCF reduction observed at 30–40 GPa. The findings highlight the anisotropic nature of GFRP, emphasizing the importance of reinforcement selection based on loading direction and structural requirements. This study provides critical insights for optimizing perforated GFRP components in modular construction and other civil engineering applications.

17 December 2025 in Sensors
Verified
Journal Article
Open access
PDF file
XZXinyu Zuo
Xinyu Zuo
Yiqing DaiYiqing Dai
Yiqing Dai
CYChao Yu
Chao Yu
Gang WangGang Wang
Gang Wang
Maintaining a safe working environment for construction workers is critical to the improvement of urban areas. Several issues plague the present safety helmet detection technologies utilized on construction sites. Some of these issues include low accuracy, expensive deployment of edge devices, and complex backgrounds. To overcome these obstacles, this paper introduces a detection method that is both efficient and based on an improved version of YOLOv8n. Three components make up the superior algorithm: the C2f-SCConv architecture, the Partial Convolutional Detector (PCD), and Coordinate Attention (CA). Detection, redundancy reduction, and feature localization accuracy are all improved with coordinate attention. To further enhance feature quality, decrease computing cost, and make corrections more effective, a Partial Convolution detector is subsequently constructed. Feature refinement and feature representation are made more effective by using C2f-SCConv instead of the bottleneck C2f module. In comparison to its predecessor, the upgraded YOLOv8n is superior in every respect. It reduced model size by 2.21 MB, increased frame rate by 12.6 percent, decreased FLOPs by 49.9 percent, and had an average accuracy of 94.4 percent. This method is more efficient, quicker, and cheaper to set up on-site than conventional helmet-detection algorithms.