Traditional noise reduction methods often struggle to balance noise suppression with the preservation of transient features in acceleration signals, especially when dealing with high-speed transient data. This study proposes a novel noise reduction method combining ensemble empirical mode decomposition (EEMD), sample entropy (SE), and improved wavelet threshold denoising (IWTD) to address the issue. The method utilizes EEMD to decompose the signal into intrinsic mode functions (IMFs) and a residual term. By setting an SE threshold (SE = 0.3), it effectively differentiates noise-dominated components from those containing significant transient features. IWTD is then applied to the noise-dominated components, and the processed components are reconstructed to yield the denoised signal. A baseline signal is generated in the lab, and noise is added to create the test set. The results show that this method achieves optimal noise reduction performance. Its effectiveness is validated through the output signal-to-noise ratio, root mean square error, and correlation coefficient. Overall, this method enhances noise reduction performance while preserving transient features. The method has been validated using real multi-layer penetration acceleration signals, supporting subsequent penetration layer identification and inversion analysis of the penetration process.
Roll-bonding has rarely been applied to prepare rods for negative thermal expansion metamaterials (NTEMs). Parameters for quantitatively assessing the isotropy and cyclic thermal stability of the thermal expansion coefficient α of NTEMs are lacking. Here, the Ti-to-Al thickness ratio in bimetallic rods for “cross-shaped” node bending-dominated NTEMs was optimized using a general model proposed in the literature. The finite element method was used to determine the optimal initial thickness ratio of the billet, as well as the reduction ratio and rolling temperature. NTEMs were prepared with roll-bonded Ti/Al rods and Ti nodes. A relatively high thermal expansion coefficient was obtained when the thickness ratio of the 7075 Al alloy of the rods was in the range of 0.56–0.60. The optimized roll-bonding process to meet this thickness ratio was as follows: a rolling temperature of 400 °C, a reduction ratio of 50%, and TA1 Ti and 7075 Al billet thicknesses of 0.5 mm and 1.5 mm, respectively. The isotropy and cyclic thermal stability ratios were proposed to quantitatively assess the isotropy and cyclic thermal stability of the NTEMs. These results help to expand the preparation and evaluation methods for NTEMs.