As a laboratory-on-a-chip application tool, digital microfluidics (DMF) technology is widely used in DNA-based applications, clinical diagnosis, chemical synthesis, and other fields. Additional components (such as heaters, centrifuges, mixers, etc.) are required in practical applications on DMF devices. In this paper, a DMF chip interconnection method based on electrowetting-on-dielectric (EWOD) was proposed. An open modified slippery liquid-infused porous surface (SLIPS) membrane was used as the dielectric-hydrophobic layer material, which consisted of polytetrafluoroethylene (PTFE) membrane and silicone oil. Indium tin oxide (ITO) glass was used to manufacture the DMF chip. In order to test the relationship between the splicing gap and droplet moving, the effect of the different electrodes on/off time on the minimum driving voltage when the droplet crossed a splicing gap was investigated. Then, the effects of splicing gaps of different widths, splicing heights, and electrode misalignments were investigated, respectively. The experimental results showed that a driving voltage of 119 V was required for a droplet to cross a splicing gap width of 300 μm when the droplet volume was 10 μL and the electrode on/off time was 600 ms. At the same time, the droplet could climb a height difference of 150 μm with 145 V, and 141 V was required when the electrode misalignment was 1000 μm. Finally, the minimum voltage was not obviously changed, when the same volume droplet with different aqueous solutions crossed the splicing gap, and the droplet could cross different chip types. These splicing solutions show high potential for simultaneous detection of multiple components in human body fluids.
The Gleeble-1500 hot simulation experimental equipment was used to investigate the effects of hot simulation compression on PH13-8Mo stainless steel with strain rates ranging from 0.1 to 10 s−1 and deformation temperatures ranging from 900 to 1150 °C. The stress–strain charts for each deformation condition clearly show the characteristics of dynamic recrystallization behavior. The rheological stress rises as the deformation temperature falls and the strain rate rises. A coupled Laasraoui–Jonas (L–J) model was developed based on the discovery that the dislocation density is crucial to the nucleation and micro-structure evolution of dynamic recrystallization during thermal deformation. The findings demonstrate that the model accurately captures the combined action of dynamic reversion and recrystallization inside the material during hot compression of PH13-8Mo stainless steel and that as deformation rises, the dislocation density first increases and subsequently drops. For calculations and numerical simulations of the evolution of the micro-structure under hot compression, the created model was integrated into the DEFORM-3D finite element simulation program. The projected micro-structure evolution of the PH13-8Mo stainless steel under various deformation circumstances is compared to the measured grain distribution, grain size, and the degree of dynamic recrystallization in the metallographic pictures. The fact that the simulated result plots resemble the metallographic charts so closely demonstrates that the L–J dislocation density model can reliably forecast how dynamic recrystallization of PH13-8Mo stainless steel would behave under hot compression.