This paper investigates the effects of Ti and Nb addition with varying Mn content on the solidification macrostructure and microstructure in the continuous casting slab of Q355 steel using optical microscopy, scanning electron microscopy, transmission electron microscopy, and electron probe microanalysis. The evolution of central segregation and MnS inclusions during thermal simulation compress deformation has been clearly established using Gleeble-1500 thermal simulation tester. The results indicate that by reducing the Mn content and adding a small amount of Ti and Nb, it is possible to refine the grain and mitigate the center segregation of Q355 steel. Mn steel with 1.25% Mn and without Ti and Nb addition exhibits the most severe center segregation. The TiNb steel with 0.52% Mn and a small amount of Ti and Nb addition showed a marked improvement in the center segregation of the slab. The Nb steel with 0.56% Mn and 0.009% Nb shows the presence of thin film ferrite along prior grain boundaries surrounded by Widmanstätten ferrite, and the central segregation has not shown significant improvement. The thermal simulation samples of the three steel types inherit the characteristics of their respective casting structures.
14CrMoR steel, possessing excellent low-temperature impact toughness and corrosion resistance, is an important material for core equipment in the coal chemical industry. In this paper, 14CrMoR steel was subjected to single-pass compression tests at deformation temperatures ranging from 900 to 1150 °C and strain rates of 0.1, 1, 5, and 10 s−1. The hot deformation behavior and constitutive relationship were investigated. The strain rate sensitivity factor m, power dissipation coefficient η, and instability parameter ξ were calculated, respectively. A power dissipation map was plotted, and a hot processing map was established. The results showed that the stress of 14CrMoR steel increased with the decrease in deformation temperature and the increase in strain rate. Dynamic recrystallization was likely to occur at high deformation temperatures and low strain rates. When the strain rate was 10 s−1, in the temperature range of 900–950 °C, the power dissipation rate was the lowest. With the increase in temperature, the power dissipation rate rose, and the maximum power dissipation rate was reached in the temperature range of 1100–1150 °C. The research on the hot deformation behavior of 14CrMoR steel has important guiding significance for the design and optimization of the process.