This paper investigates the effects of Ti and Nb addition with varying Mn content on the solidification macrostructure and microstructure in the continuous casting slab of Q355 steel using optical microscopy, scanning electron microscopy, transmission electron microscopy, and electron probe microanalysis. The evolution of central segregation and MnS inclusions during thermal simulation compress deformation has been clearly established using Gleeble-1500 thermal simulation tester. The results indicate that by reducing the Mn content and adding a small amount of Ti and Nb, it is possible to refine the grain and mitigate the center segregation of Q355 steel. Mn steel with 1.25% Mn and without Ti and Nb addition exhibits the most severe center segregation. The TiNb steel with 0.52% Mn and a small amount of Ti and Nb addition showed a marked improvement in the center segregation of the slab. The Nb steel with 0.56% Mn and 0.009% Nb shows the presence of thin film ferrite along prior grain boundaries surrounded by Widmanstätten ferrite, and the central segregation has not shown significant improvement. The thermal simulation samples of the three steel types inherit the characteristics of their respective casting structures.
To address the failure of 25MnB crawler track steel due to insufficient strength and toughness, this study designed a new type of 25MnB crawler track steel and investigated the effects of the Nb content on its mechanical properties, microstructure, dislocation evolution, and precipitation behavior. The experimental results show that, compared to 25MnB steel without Nb, the addition of 0.03% Nb significantly increased the yield strength of the experimental steel to 1450 MPa, with an elongation rate of 15.9%. The room-temperature impact energy showed a slight improvement, while the low-temperature impact absorption energy improved notably, reaching 36 J at −40 °C. The microstructural characterization and analysis revealed that increasing the Nb content refined the effective grain size of prior austenite and martensite. The (Nb, Ti)C precipitates provided a higher precipitation driving force, promoting the formation of precipitates and increasing the average dislocation density. Additionally, the increased proportion of high-angle grain boundaries (HAGBs) enabled grain boundaries and precipitates to jointly hinder crack propagation. This study demonstrates that Nb-Ti microalloying can effectively enhance the strength, toughness, and plasticity of track steel, demonstrating promising application prospects.