The materials used in the marine environment are generally selected for their high performances in aggressive operational media. This is also the case for marine propellers, which are mainly manufactured from cast nickel–aluminum bronze (NAB), due to their favorable mechanical properties and corrosion resistance. This study is focused on maximizing the efficiency of pulsed laser cladding through coaxial powder feeding, aiming to develop it as a sustainable reconditioning method for NAB propellers. A pulsed-wave laser (Trumpf TruPulse 556) and a cladding head (Precitec WC 50) were used for cladding of CuNi-alloyed powder on an NAB substrate. One of the main challenges was the high reflectivity of the copper matrix, present in both the base material of the propeller and in the powder, which significantly reduces laser energy absorption. However, good-quality cladded layers were obtained by optimizing the process cladding parameters. The coatings were characterized by optical and scanning electron microscopy. Microhardness values indicated transition regions within the coating layer. The results demonstrate that laser cladding with pulsed lasers is an effective and promising surface engineering method for reconditioning of damaged marine propellers. The obtained results create a path for future research aimed at extending the service life of copper-based marine components.
Aiming to enhance the surface properties of low-carbon steel, NiCrBSi coatings containing 10 wt.% Nb were fabricated via pulsed laser cladding. Samples were realized with laser power ranging from 2800 to 3200 W. Scanning electron microscopy (SEM), coupled with energy-dispersive X-ray (EDX) analysis, was used to examine the microstructure and chemical composition. X-ray diffraction (XRD) was employed to evaluate the new phases formed within the coatings compared to the initial powder composition. Hardness measurements and corrosion resistance in a 3.5% NaCl solution were conducted to evaluate the effect of the Nb alloying on the properties of the cladded layers. In all cases, good metallurgical bonds were formed between the coatings and the substrate. However, the coatings produced at low laser power were thinner, and the substrate experienced more intense thermal exposure, resulting in increased dissolution of iron from the substrate. Increasing the laser power significantly enhanced the hardness of the coating compared to coatings produced using lower power. These phenomena can be the result of improved powder cladding efficiency, which can lead to thicker coatings with enhanced corrosion resistance. The results suggest that Nb addition can lead to improved mechanical behavior and corrosion resistance, but the process is highly dependent on the parameters and mainly on the laser power.
This study investigates the fatigue failure of fiber-reinforced rubber used in automotive shock-absorbing elements subjected to cyclic loads. A quantitative simulation model integrated with material analysis to predict the service life and performance decay of these viscoelastic dampers was introduced. Failure is governed by a degradation factor that models accumulating fatigue damage and results in a predictable, cyclic loss of maximum force capacity; specifically, the model accurately predicts a 36.3% reduction in peak force (from 111.44 N to 70.97 N) over the first 10 fatigue cycles. Crucially, the model incorporates the non-linear stiffness behavior caused by a fiber pull-out mechanism, which transitions load resistance from high elastic integrity to lower frictional forces post-critical displacement. These findings establish a direct, quantitative link between microstructural failure (verified via SEM) and observed performance decay, offering key insights for maintenance planning and material selection.