Abhay Patil

Dr. Abhay Patil


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 September 2018 in Journal of Energy Resources Technology
Verified
Journal Article
Closed access
PDF file
YCYiming Chen
Yiming Chen
APAbhay Patil
Abhay Patil
YCYi Chen
Yi Chen
CBChangrui Bai
Changrui Bai
YWYintao Wang
Yintao Wang
GMGerald Morrison
Gerald Morrison

27 March 2019 in Journal of Energy Resources Technology
Verified
Journal Article
Closed access
PDF file
SPSahand Pirouzpanah
Sahand Pirouzpanah
APAbhay Patil
Abhay Patil
YCYiming Chen
Yiming Chen
GMGerald Morrison
Gerald Morrison

APAbhay Patil
Abhay Patil
SGSujan Gudigopuram
Sujan Gudigopuram
BABurak ayyildiz
Burak ayyildiz
ADAdolfo Delgado
Adolfo Delgado
GMGerald Morrison
Gerald Morrison
A four stage helicoaxial pump was tested under varying operating conditions. A range of inlet pressures, rotational speeds (3000, 3600 rpm), and gas void fractures (GVFs) were considered for two fluid viscosities. The head developed and power input to run the pump were recorded. Head, power input and efficiency decrease as the GVF increases with best efficiency point (BEP) moving towards lower flow rate conditions. Dimensional analysis was conducted to evaluate the applicability of current affinity laws to the two-phase flow performance of the pump under consideration. Dimensionless head coefficient and power coefficients were defined for two-phase flow, considering the homogeneity in the two-phase fluid properties. Deviations in the two-phase affinity coefficients from the common law curve increases with GVF. To bridge this gap, a new correlation is proposed with a revised flow coefficient that allows all the head coefficient data to collapse on a single line with a greater degree of accuracy.

3 February 2020 in Journal of Fluids Engineering
Verified
Journal Article
Closed access
PDF file
APAbhay Patil
Abhay Patil
MKMarie Kasprzyk
Marie Kasprzyk
ADAdolfo Delgado
Adolfo Delgado
GMGerald Morrison
Gerald Morrison
Subsea production fluid is quite often characterized by the presence of frac sand, which causes wear within the pump, and alters the performance envelop. One of the design parameters critically affecting reliability is the thrust load generated by an impeller. The change in thrust load due to the erosion of the pump stages is not completely understood, and no relationship exists to foresee these reactive forces due to the complexity involved in predicting the flow characteristics. The purpose of this study is to understand the change in axial thrust due to commonly encountered wear mechanisms across the pump section especially wear across stage clearance seals. Based on in-house erosion testing of a mixed flow pump, three mesh models were built with each representing the pump condition at three different time intervals, namely, 0 h, 52 h, and 117 h of the total test time. The pump numerical models were validated using performance data collected from experimental testing. Axial thrust was found to increase with an increase in wear rate across stage seals. Since the increased clearance causes head degradation as well as an increase in thrust, the relationship of this head degradation is correlated with a change in thrust to further expand the affinity laws.

1 November 2019 in Journal of Petroleum Science and Engineering
Verified
Journal Article
Closed access
APAbhay Patil
Abhay Patil
SSShyam Sundar
Shyam Sundar
ADAdolfo Delgado
Adolfo Delgado
JGJose Gamboa
Jose Gamboa

16 October 2019 in Journal of Energy Resources Technology
Verified
Journal Article
Closed access
PDF file
PLP. Liu
P. Liu
GMG. Morrison
G. Morrison
APAbhay Patil
Abhay Patil