A four stage helicoaxial pump was tested under varying operating conditions. A range of inlet pressures, rotational speeds (3000, 3600 rpm), and gas void fractures (GVFs) were considered for two fluid viscosities. The head developed and power input to run the pump were recorded. Head, power input and efficiency decrease as the GVF increases with best efficiency point (BEP) moving towards lower flow rate conditions. Dimensional analysis was conducted to evaluate the applicability of current affinity laws to the two-phase flow performance of the pump under consideration. Dimensionless head coefficient and power coefficients were defined for two-phase flow, considering the homogeneity in the two-phase fluid properties. Deviations in the two-phase affinity coefficients from the common law curve increases with GVF. To bridge this gap, a new correlation is proposed with a revised flow coefficient that allows all the head coefficient data to collapse on a single line with a greater degree of accuracy.
Multiphase pumps are increasingly being used to transport gas-liquid multiphase flow in the oil and gas industry. Complexity of two-phase flow interaction and varying designs of multiphase pumps pose significant challenges to developing generalized performance prediction tool similar to the affinity laws. The goal of this study is to characterize the performance of two multiphase pumps with different specific speeds using experimental data to develop generalized prediction models. Initially, the performance is investigated in the terms of head, power input and efficiency for different Gas Volume Fractions (GVF). Dimensional analysis is performed to evaluate the effect of pump geometry and GVF. Head degradation due to the presence of gas is presented in the terms of dimensionless numbers. These numbers represent the systematic change in the energy loss due to two phase flow interaction and inherent characteristics of the pump design. This is utilized to develop a generalized model for two phase flow. The study is concluded by validating the model using experimental data.