Lattice structures have the characteristics of light weight, excellent heat dissipation and mechanical properties. Because of excellent properties, lattice structures have been widely used in aerospace, automobile manufacturing, biomedical and other fields. At present, additive manufacturing is the mainstream method for manufacturing lattice structures. This study reviews the existing literature on additive manufacturing of lattice structures, introduces manufacturing methods, and summarizes the influencing factors of forming quality. In addition, the topology optimization of the unit cell and the gradient design of the lattice structure are discussed, and the future research direction of the lattice structure is proposed.
In order to predict the wrinkling of sheet metal under the influence of fluid pressure and temperature during warm/hot hydroforming, a numerical simulation model for sheet wrinkling prediction was established, taking into account through-thickness normal stress induced by fluid pressure. From simulations using linear and quadratic elements, respectively, it was found that the latter gave results that were much closer to experimental data. A novel experimental method based on an improved Yoshida Buckling Test (YBT) was proposed for testing the wrinkling properties of sheets under the through-thickness normal stress. A wrinkling coefficient suitable for predicting wrinkling was also presented. Based on the numerical simulations, an experimental validation of wrinkling performance was conducted. Ridge-height curves measured along the main diagonal tensile direction of the sheet were presented and showed that the wrinkling prediction criterion provided good discrimination. Furthermore, the wrinkling properties of several different materials were simulated to evaluate the accuracy of the prediction method, and the results revealed that the improved YBT gave good predictions for wrinkling in the conventional sheet metal forming process, while the prediction results for wrinkling in warm/hot sheet hydroforming were also accurate with the fluid pressure of zero.
In order to investigate the effect of hot isostatic pressing (HIP) process parameters on the properties and fracture behavior of tungsten alloy, HIP experiments with different process parameters were carried out, and the relative density, Rockwell hardness, tensile properties, and tensile fracture behavior were analyzed. The results show that after HIP, the tungsten alloy samples obtained further densification, higher relative density and hardness, and lower dispersity. At 1300 °C and 140 MPa, the sintered bar achieved excellent mechanical properties: yield strength increased by 16.5%, tensile strength increased by 16.1%, and fracture strength increased by 85.3%. Comparing the two processes, the mechanical properties of tungsten alloy powders formed directly via HIP were not as good as those of the sintered bars. In addition, after HIP, the fracture mode of the tungsten alloy sintered bar samples was mainly ductile tear, and that of the tungsten alloy powder samples was mainly a full brittle fracture.
In this study, the size of molten pool and the porosity of parts under different processing parameters are studied using numerical simulation. According to the results, the appropriate processing parameters were selected to simulate the temperature and residual stress distribution during the forming process of body-centered cube (BCC), face-centered cube (FCC) and rhombic dodecahedron (Dode) lattice structures. In addition, three lattice structures were fabricated via selective laser melting (SLM) technology, and quasi-static compression experiments were carried out to study their mechanical properties. The results show that the high temperature parts of the three structures are all under the node and their adjacent pillars, and the closer to the nodes, the higher the temperature. The residual stress of the Dode structure is the highest, reaching 1218.2 MPa. It is also found that the residual stress in the Z direction is the largest, which plays a dominant role in the forming process. Through compression experiments, it is found that diagonal shear failure occurs in all three lattice structures, and Dode shows the best compression performance.
24 September 2021 in The International Journal of Advanced Manufacturing Technology