Olga Liskevych

Dr. Olga Liskevych

orcid

Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 January 2026 in Lasers in Manufacturing and Materials Processing
Verified
Journal Article
Open access
PDF file
GZGabriela Lugão de Souza Zatta
Gabriela Lugão de Souza Zatta
OLOlga Liskevych
Olga Liskevych
Milton Sergio Fernandes de LimaMilton Sergio Fernandes de Lima
Milton Sergio Fernandes de Lima
RSRafael Siqueira
Rafael Siqueira
Diego CelentanoDiego Celentano
Diego Celentano
SCSheila Medeiros de Carvalho
Sheila Medeiros de Carvalho
Laser beam forming is a non-contact process that uses a laser beam as a heat source to deform components. In this study, the microstructural and mechanical aspects of an aluminum sheet of class AA6013-T4 were studied after shaping using a fiber laser. The surfaces of the aluminum plates were coated with graphite to increase their absorptivity. Under the conditions of 200 W power, treatment speed of 3 mm/s, and focal diameter of 0.5 mm on the surface of the plate, one to three runs were performed for each sample. The width and depth of the remelted lines did not vary significantly with the number of runs, whereas the in-depth hardness profile tended to become uniform as the number of irradiation cycles increased. This study indicated a tendency towards tensile (positive) residual stress in both the longitudinal and transverse directions, with relaxation in the free part of the sheet. These components have been associated with bending angles ranging from 0.04 to 0.13 rad, depending on the number of laser runs. The maximum tensile stresses measured in the fusion zone, which was transversal to the laser path, were approximately 100 MPa, independent of the number of runs.