In the present study, 5-fluorouracil-loaded niosomal nanoparticles were successfully prepared and coated with chitosan and subsequently crosslinked by tripolyphosphate to form niosomal nanogels. The prepared niosomal formulations were fully characterized for their particle size, zeta potential, particle morphology, drug entrapment efficiency, and in vitro drug release profile. The prepared niosomal nanocarriers exhibited nanoscale particle sizes of 165.35 ± 2.75-322.85 ± 2.75 nm. Chitosan-coated and TPP-crosslinked niosomes exhibited a slightly decreased in particle size and a switch of zeta potential from negative to positive values. In addition, high yield percentage, drug encapsulation efficiency, and drug loading values of 92.11 ± 2.07 %, 66.59 ± 6.06, and 4.65 ± 0.5 were obtained for chitosan-coated formulations, respectively. Moreover, lowering the rate of 5-FU in vitro release was achieved within 72 h by using chitosan-coated formulations. All prepared formulations revealed hemocompatible properties in hemolysis assay with less than 5 % hemolysis percentage at their higher possible concentrations (500 µM and 1 mM). The cell viability by MTT assay showed higher anticancer activity against B16F10 cancerous cells and lower cytotoxicity toward NIH3T3 normal cells than control and pure 5-FU in the studied concentration range (10-100 µM). Investigating the cell migration inhibition properties of fabricated formulations revealed similar results with in vitro cell viability assay with a higher migration inhibition rate for B16F10 cells than NIH3T3 cells, controls, and free 5-FU.
The diverse properties and applications of chitosan materials require a broad spectrum of characterization techniques. In the meantime, due to chitosan’s high gel-forming capability, the rheological properties of chitosan solutions vary significantly depending on their state, i.e., solution or gel. To elucidate the solution and gel-based characteristics of chitosan, the present study was conducted to thoroughly investigate its rheological characteristics at different concentrations (1.25%, 2.5%, and 4% w/v), using various steady and dynamic rheological measurements and different mathematical models. The results showed that the concentration of chitosan solutions strongly affects their rheological properties in terms of shear stress, viscosity, and various dynamic rheological characteristics, through strain, angular frequency, and temperature sweep tests. In this regard, an elastic behavior was observed for low concentrations of chitosan solutions at lower shear strains, while the higher concentrations and higher shear strains exhibited predominantly viscous behavior. In frequency sweep measurements, the 1.25% and 2.5% w/v chitosan solutions showed viscous-like behavior and the 4% w/v solution exhibited solid-like behavior with almost constant storage and loss modulus profiles over the studied frequency range. According to temperature sweep measurements, viscous-like behavior was dominant at lower temperatures, which resulted in elastic gel structures at higher temperatures. Investigating the recoverability of prepared solutions by cyclic strain measurements revealed that the higher-concentration solutions of chitosan possess the desired capability to recover their structure. The results of this study provide detailed rheological insights into chitosan solutions suitable for designing and developing various chitosan-based products for different applications.