In tool and mold making, components are typically first pre-machined in a soft state with residual stock allowance, as economical production is not possible in a hardened state due to the enormous tool wear. This extends the process chain and therefore also the throughput times. This paper presents an innovative tool concept for a solid carbide end mill in order to be able to carry out roughing and finishing in a hardened state. First, the structure of the innovative solid carbide end mill is described. Afterwards, the results of experimental tests are presented and discussed. These describe the suitability of the tool concept and include further investigations that examine the influence of the helix angle on the process behavior during the machining of the tool steel Toolox 44. To evaluate the process behavior, the development of process forces, chip formation, tool wear and component quality over the tool life are analyzed.
Monitoring process stability and tool condition is essential for ensuring machining quality and efficiency. This study investigates the influence of sensorized tool holders on dynamic properties and machining results. Three clamping conditions, one conventional and two different sensor-integrated tool holders (equipped with strain gauges or piezoelectric force sensors), are compared. Experimental modal analyses are carried out to determine the frequency-dependent dynamic compliance of the systems. Machining tests using a developed reference workpiece enable the investigation of process forces, wear development, and the surface quality achieved under real conditions. The results show that the dynamic behavior of the tools varies significantly depending on the respective excitation frequency, whereby the different structural properties of the tool holders have a clearly measurable influence on their dynamic properties, particularly near process-relevant excitation frequencies. However, no clear deterioration in terms of process stability or machining performance can be determined. In some cases, the sensorized tool holders can contribute to reduced tool wear and improved process stability. These findings emphasize that sensorized tool holders do not necessarily worsen the machining results and can be applied without negative effects when aligned with the system’s modal characteristics.
To increase sustainability in the field of machining with regard to energy efficiency improvement and resource conservation, accurate tool wear classification is of a paramount importance. In particular, optical wear monitoring approaches that use artificial intelligence and computer vision techniques have shown enormous potential in the recent past. A critical point to these approaches is the requirement of a lage image dataset of worn tools. The generation of such dataset is associated with a waste of resources, since recording of the data has to be done elaborately during ongoing production and classified by an expert. In this paper, the possibilities of generating synthetic training images with the help of generative adversarial networks (GANs) were investigated. A limited set of images was acquired for training GANs which then were used to increase the number of images for the training of our tool wear classificator. The approach enables a resource-efficient approach for the training process such that the accuracy and robustness of tool wear classification systems through the use of GANs can be ensured.