With the accelerated development of urban underground spaces, prefabricated tunnel linings have become a research focus due to their advantages in construction efficiency and cost effectiveness. However, issues such as stress concentration at joints and insufficient overall stability hinder their broader application. This study investigates a cut-and-cover prefabricated tunnel project in the Chongqing High-Tech Zone through scale model tests and numerical simulations to systematically compare the mechanical behaviors of cast-in situ linings and three-segment prefabricated linings under surrounding rock loads. The experimental results show that the ultimate bearing capacity of the prefabricated lining is 15.3% lower than that of the cast-in situ lining, with asymmetric failure modes and cracks concentrated near joint regions. Numerical simulations further reveal the influence of joint stiffness on structural performance: when the joint stiffness is 30 MN·m/rad, the bending moment of the segmented lining decreases by 37.7% compared to the cast-in situ lining, while displacement increments remain controllable. By optimising joint pre-tightening forces and stiffness parameters, prefabricated linings can achieve stability comparable to cast-in situ structures while retaining construction efficiency. This research provides theoretical and technical references for the design and construction of open-cut prefabricated tunnel linings.

In response to the issue of local damage to mountainous bridges easily caused by rockfall impacts, carbon fiber cloth and steel plate strengthening methods were adopted to deeply study the impact of the width of carbon fiber cloth and steel plates on the strengthening effect. This study investigates the strengthening effectiveness of Carbon Fiber-Reinforced Polymer (CFRP) wraps and steel jackets on circular bridge piers, utilizing the ABAQUS finite element method. The analysis focuses on the effects of varying load conditions and confinement widths ranging from 100 to 200 cm, with a specific case study of a bridge pier in Nanchuan District, Chongqing. The research results show that the width of carbon fiber cloth and steel plates has a significant impact on the bridge pier’s impact resistance and damage resistance. There exists an optimal strengthening width that maximizes the strengthening effect. The stress distribution and displacement changes under different load conditions are affected by the width of the steel plate; the wider the steel plate, the better the strengthening effect, but the effect is not strictly linear. A comprehensive analysis method integrating multi-directional stress and displacement data was developed, incorporating weighting factors based on structural safety relevance. For both strengthening methods, a set of fitted formulas for widths between 100 cm and 200 cm was derived. This study provides systematic insights and practical guidance for the design of impact-resistant strengthening systems for bridge piers.

To address force uniformity and corrosion issues in slope reinforcement, this paper presents a field implementation of pressure-uniformly-dispersed Carbon-Fiber-Reinforced Polymer (CFRP) anchor cables integrated with Fiber Bragg Grating (FBG) sensing technology. A tensioning trial was conducted on a dangerous rock project on Guangyang Island, Chongqing, utilizing a distributed FBG array (0.5 m spacing) for full-length strain monitoring. The results confirm that, under the specific conditions of this project, the anchorage segment exhibits the characteristic two-stage behavior of “delayed activation–uniform bearing” previously documented in bonded anchor systems, with a critical transition observed at approximately 120 kN. Beyond this threshold, the anchorage efficiency reached approximately 85%, validating the three-stage uniformly dispersed design for this specific geological context. While the load transfer mechanism aligns with established bonded anchor mechanics, this study demonstrates the practical feasibility of high-resolution distributed sensing in CFRP anchor systems, providing benchmark data for construction quality control and long-term health monitoring of similar slope reinforcement projects.