The direct current potential drop method (DCPDM) is widely used to determine the crack length in fatigue experiments. In practice, some special features of this method must be considered. Aside from general information on the experimental setup and calibration, some special features of the method, such as the influence of the ambient atmosphere and the application of the method to ferromagnetic materials, are presented and discussed. In addition, with the multiple potential drop measurement, a method is presented which improves the resolution of the DCPDM for detection of cracks and allows to determine crack initiation sites. The capabilities provided by this method are demonstrated on the basis of measurements undertaken on notched round bars and single edged notched specimens.
This work is devoted to the development of an experimental method for studying the energy balance during cyclic deformation and fracture. The studies were conducted on 304 stainless steel AISE and titanium alloy OT4-0 samples. The investigation of the fatigue crack propagation was carried out on flat samples with different geometries and types of stress concentrators. The heat flux sensor was developed based on the Seebeck effect. This sensor was used for measuring the heat dissipation power in the examined samples during the fatigue tests. The measurements showed that the rate of fatigue crack growth depends on the heat flux at the crack tip.