1 April 2019 in Engineering Fracture Mechanics
13 November 2013 in Quantitative InfraRed Thermography Journal
The presented work is devoted to the experimental study of heat dissipation process caused by fatigue crack propagation. To investigate a spatial and time temperature evolution at the crack tip, set of experiments has been carried out using plate titanium specimens with pre-grown centred fatigue crack. An original mathematical algorithm for experimental data treatment has been developed to obtain the power of heat dissipation caused by plastic deformation at the crack tip. The algorithm includes spatial-time filtration and relative motion compensation procedures. The time dependence of the stored energy was calculated as the difference between work caused by plastic deformation near the crack tip and heat dissipation energy obtained from experimental data. As a result, it has been shown that the stored energy has to accumulated during the fatigue test and has to be equal to zero when the crack reaches the critical length corresponding to the failure of sample.
12 May 2014 in Fatigue & Fracture of Engineering Materials & Structures
16 March 2016 in Quantitative InfraRed Thermography Journal
The real time temperature measurement coupled with analysis of loading history data allows us to carry out the study of energy balance in metals under deformation and failure. Two independent techniques for estimation of deformation and failure induced heat sources in loaded sample were proposed. The techniques are based on temperature data treatment and original heat flow detector. The dissipated energy evolution was studied under quasistatic loading of Ti–0.8Al–0.8Mn sample and under fatigue crack propagation. Two regimes of energy dissipation at crack tip during its propagation in Paris regime were shown. The experimental data about dissipated and store energy evolution were supported by 3D numerical simulation based on the original theoretical model.
29 December 2015 in Fracture and Structural Integrity
This work is devoted to the development of an experimental method for studying the energy balance during cyclic deformation and fracture. The studies were conducted on 304 stainless steel AISE and titanium alloy OT4-0 samples. The investigation of the fatigue crack propagation was carried out on flat samples with different geometries and types of stress concentrators. The heat flux sensor was developed based on the Seebeck effect. This sensor was used for measuring the heat dissipation power in the examined samples during the fatigue tests. The measurements showed that the rate of fatigue crack growth depends on the heat flux at the crack tip.
10 January 2021 in Acta Mechanica