Train derailments may have catastrophic consequences, and therefore suitable measures should be designed and installed at specific safety-relevant sites to mitigate their effects. Mitigation measures, such as guard rails and containment walls, aim at restraining the motion of the derailed vehicle using suitable derailment containment devices. However, the design and structural sizing of these devices is challenging as the quantification of the loads caused by the impact with the vehicle is complex. The aim of this paper is to extend previous work from the same authors aimed at defining a non-linear multi-body model for the simulation in time-domain of the post-derailment behaviour of a railway vehicle and the impact on a derailment containment wall. The extension presented in this paper is concerned with the model of the interaction of the derailed vehicle with the sleepers and with the ballast. To this aim, an algorithm is introduced to manage the different possible contact conditions the wheels of the vehicle may undergo during the derailment process: contact with the rail, with the sleepers and with the ballast. Then, a model of the impact between the derailed wheels and the sleepers is introduced, and a terramechanic model defining the forces acting on the wheels sinking in the ballast is established. The effect of the accurate modelling of forces exchanged by the derailed wheels with the sleepers and the ballast is quantified for a relevant derailment scenario and shown to be highly relevant to the estimation of the impact loads applied to the containment structure.
In this paper, a model-based approach for the identification of the railway vertical track alignment from simulation data is presented. The proposed methodology is based on the application of the unknown input observer algorithm. The model of a conventional train is used to simulate the acceleration levels that vehicle-mounted sensors (e.g., on the bogies and carbody) would measure during operation. Simulations are carried out at a constant speed on both straight and curved tracks, including different types of track geometry components (namely longitudinal level, alignment, and cross-level) to assess the algorithm capability to identify the input irregularity. The primary focus is on the identification of mean vertical track alignment, a critical irregularity component for safety issues. In the analysed cases, the comparison between the measured and reconstructed signal histories are quite satisfactory, with maximum errors in the order of 15% and 29% along straight and curved tracks. Comparing the frequency content of the signals, a significantly higher degree of accuracy is observed (with maximum errors of 5–10% depending on the track layout), which demonstrates that the proposed methodology is suitable for track irregularity identification and monitoring purposes using an instrumented vehicle.
Rail transport is widely acknowledged as one of the safest modes of land transportation. However, derailments remain a significant safety concern that can lead to catastrophic outcomes. This paper presents results from a research aimed at supporting the design of effective derailment containment measures through numerical simulation techniques, employing a multibody model to simulate the post-derailment behaviour of a railway trainset. This model is combined with a finite element model of a track-based derailment containment device and is used to predict the forces on this structure resulting from the impact with the derailed train. The key innovations presented in this paper include the modelling of the entire trainset instead of a single vehicle, considering the effect of inter-vehicle interaction forces due to the traction gear and buffers, and the modelling of guard rails as an alternative to derailment containment walls which were previously investigated. The introduction of these new features enhances the scope and accuracy of the model, particularly providing a more accurate prediction of the impact forces which considers the effect of the interaction between adjacent vehicles, and the possibility to compare different derailment mitigation measures.