Comprehensive studies of hydrogen embrittlement in high-strength austenitic alloys under cryogenic conditions are scarce, leaving the combined effect of hydrogen charging and extreme temperatures largely unexplored. Given the demands of cryogenic applications such as hydrogen storage and transport, understanding material behavior under these conditions is crucial. Here, we present the first systematic study of hydrogen’s effect at liquid helium temperature (4.2 K) on the mechanical properties of precipitation hardened austenitic alloys, specifically the nickel-based Alloy 718 and austenitic stainless steel A286. Both materials were subjected to pressurized hydrogen charging at 473 K followed by slow strain rate tensile testing at room temperature and at 4.2 K. Hydrogen charging caused significant ductility loss at room temperature in both alloys. In contrast, testing at 4.2 K resulted in increased strength and no evidence of hydrogen embrittlement. Notably, materials pre-charged with hydrogen and tested at 4.2 K exhibited higher stress drop amplitudes and increased strain accumulation during serration events, suggesting persistent hydrogen–dislocation interactions and possible enhanced dislocation pinning by obstacles such as Lomer–Cottrell locks. These results indicate that while hydrogen influences plasticity mechanisms at cryogenic temperatures, embrittlement is suppressed, providing new insight into the safe development of austenitic alloys in cryogenic hydrogen environments.
Within this paper, the authors present a novel multifunctional piezo – temperature sensor concept for flow front, cure and structural health monitoring of composite parts. The multifunctional sensor is made of piezo disc in series to a Pt100 temperature sensor used a shunt resistor. In order to measure the impedance of the Piezo a signal generator is connected to the ground electrode of the piezo and the PT100 temperature sensor. The current through the piezo is measured via the Pt100. For actuation, a frequency modulated chirp signal is used and the response voltage over the PT100 sensor is measured. Out of the FFT of the voltage response, the impedance of the piezo sensor can be determined. The developed sensor concept offers several advantages. Only one data acquisition unit for process and SHM is required. The time resolution of cure monitoring can be drastically reduced. The integration of a Pt100 as shunt resistor allows the measurement of the temperature during the manufacturing and usage of the part, where the knowledge of the temperature distribution can be used for effective temperature compensation techniques during SHM with guided waves.
A fiber-optic interferometric technique aimed at measuring the deflection of aircrafts’ morphing wings is presented. The wing deflection induces a strain in the sensing fiber optic coils that are firmly fixed onto the wing. A change of the phase angle of the light propagating through the fiber is measured by an ‘all-in-fiber’ Michelson interferometer based on a 3 × 3 fiber-optic coupler. Two light sources of different coherence lengths and wavelengths are simultaneously used to ensure a wide measurement range and high accuracy. A new technique for determination of the zero deflection point using the cross-correlation of the two interferograms is proposed. The experiments performed on a specimen made of a carbon-fiber-reinforced plastic honeycomb structure demonstrated a relative uncertainty <1% and a precision of about 0.06° in the measuring range ±5° of the morphing wing deflection.