This article features with the enhancement of the static coefficient of friction by laser texturing the contact surfaces of tribological systems tested under dry friction conditions. The high-rate laser technology was applied for surface texturing at unprecedented processing rates, namely using powerful ultrashort pulses lasers in combination with ultrafast polygon-mirror based scan systems. The laser textured surfaces were analyzed by ion beam slope cutting and Raman measurements, showing a crystallographic disordering of the produced microscopic surface features. The laser induced self-organizing periodic surface structures as well as deterministic surface textures were tested regarding their tribological behavior. The highest static coefficient of friction was found of µ20 = 0.68 for a laser textured cross pattern that is 126% higher than for a fine grinded reference contact system. The line pattern was textured on a shaft-hub connection where the static coefficient of friction increased up to 75% that demonstrates the high potential of the technology for real-world applications.
The reduction in aerodynamic drag remains a crucial pathway for enhancing turbomachinery efficiency. Riblet structures are a well-established passive technique to reduce viscous drag, but their application has been constrained by the challenge of adapting size and orientation to match the local flow conditions. This study presents a novel laser-based fabrication process developed at the Laserinstitut Hochschule Mittweida, which enables the production of continuously adapted riblets on complex curved surfaces. Numerical simulations were employed to design riblet patterns for the NACA0012 airfoil at zero angle of attack, followed by laser manufacturing and high-resolution surface characterization. Aerodynamic performance was evaluated through wake surveys in a Göttingen-type wind tunnel at the Jade University of Applied Sciences. The results validate the numerical design approach and show that tailored riblet structures provide a notable improvement in drag reduction compared to constant geometries, with relative gains of about for the one-sided and for the two-sided application. These findings underline the potential of advanced laser-based manufacturing processing to enable riblet integration in turbomachinery under industrially relevant conditions.